Cole & Bright Radar 360+ Linkable Jakob Magnet Quick Start Manual page 3

OPERATING INSTRUCTIONS
The switch located on the top of the solar light housing
(under the weatherproof flap) is to turn on the product and also to link your
Radar 360˚ linkable lights together (if you are creating a linked network)
CHARGING YOUR RADAR 360˚ LIGHTS
FOR THE FIRST TIME
1. Find a location where your light is exposed to full sunlight for at least 8
hours. This will typically require a full day so start charging in the morning.
2. Lift the weatherproof flap to access the
Smart Controls.
3. Turn your light switch to the "M"
position for charging to commence.
4. After charging is complete or it is getting
dark, turn your switch to OFF until you are
ready to start the LINK process. This
prevents the battery from running down
again, if there is a delay between charging,
LINKING and installation.
5. Always restore the weatherproof flap
when not using the switches.
LINKING YOUR RADAR 360˚ LIGHTS FOR THE FIRST TIME
Only TWO (2) Lights (
1. Make sure your lights are fully charged before you commence
the Link procedure.
2. Take the 2 lights you wish to
pair and place the lights standing up
on a level flat surface so you can
access the switch under the
weatherproof flap.
3. Choose one light to be a
Master light. The other light(s)
will then be Secondary light.
for linking 3 or more lights, please see website)
H
OFF
M
H
OFF
M
MASTER
SECONDARY
L-H
S
L-H
S
3