6.8.1 Auxiliary Functions...... 28 Table of Contents 6.8.2 Functions/Programmes Selec- 1 Safety Instructions ......ted by Pressing the Function Intended Use ........ Keys for 3 Seconds ....Safety of Children, Vulnerable Per- End Time ........30 sons and Pets ......6.10 Starting the Programme....
Page 3
Please read this user manual first! Dear Customer, Thank you for choosing Beko product. We hope that you get the best results from your product which has been manufactured with high quality and state-of-the-art technology. Therefore, please read this entire user manual and all other accompanying documents care- fully before using the product.
1 Safety Instructions This section includes the safety • The product must only be instructions necessary to pre- used for washing and rinsing vent the risk of personal injury or of laundry that are marked ac- material damage. cordingly • This appliance is intended to Our company shall not be held be used in household and responsible for damages that...
ing use of the appliance in a • Cut the power cable and the product safe way and the break and deactivate the lock- hazards involved. ing mechanism of the loading • Children under the age of 3 door before disposing of the should be kept away unless product for children’s safety.
• When unplugging the appli- Installation Safety ance, don't hold the power • Check the information on the cord, but the plug. manual and installation in- • Make sure the plug is not wet, structions to prepare the dirty or dusty. product for installation and Handling Safety make sure the electrical...
Page 7
• Place the product on a level be running from the tap in a and hard surface and balance minute in order for the product with the adjustable legs. to function properly. If the wa- • Connect the product to a ter pressure is above 1 MPa grounding plug protected by a (10 Bars), a pressure-reducing...
• Make sure pets do not climb Operational Safety inside the product. Check in- • When you are using the appli- side the product before use. ances, use only detergents, • Do not force open the locked softeners and supplements loading door.
charge hose is connected to • Do not use sharp or abrasive the tap. Do not touch the dis- tools to clean the product. Do charge water. not use household cleaners, • Take the following precautions soap, detergent, gas, gasol- to prevent formation of biofilm ine, thinner, alcohol, varnish, and malodours:...
2 Important Instructions for Environment 2.1 Compliance with WEEE Direct- This product complies with EU WEEE Directive (2012/19/EU). This product bears a classifica- tion symbol for waste electrical and electronic equipment (WEEE). This product has been manu- factured with high quality parts and materials which can be reused and are suitable for re- cycling.
4 Installation 4.1 Appropriate Installation Loca- Please read the “Safety Instructions” tion section first! • Place the product on a hard and level Your washing machine automatically floor. Do not place it onto a carpet with detects the amount of laundry high pile or other similar surfaces.
Tilt the machine back slightly. Rest the tabs NOTICE of Cover A against the lower panel. Com- Remove the transportation safety plete the assembly by rotating the cover. bolts before operating the product. • Cover B and the Cap are optional. If avail- Otherwise, the product will get dam- able, attach cover B and the Cap.
e. The end of the hose should not be bent, it should not be stepped on and the hose must not be pinched between the drain and the product. Otherwise, water dis- charge issues may emerge. f. If the length of the hose is too short, use it by adding an original extension hose.
• Connection must comply with national 4.8 Start Up regulations. Before starting to use the product make sure • The electrical connection cable infrastruc- that the preparations described in section ture of the product must be adequate and “Environmental instructions” and “Installa- suitable for product requirements.
• Wash trousers and delicate laundry turned not open, apply the solutions provided for inside out. “Loading door cannot be opened” error in • Laundry that are subjected to materials the Troubleshooting section. such as flour, lime dust, milk powder, etc. 5.5 Correct Load Capacity intensely must be shaken off before pla- cing into the product.
Page 17
( ) a syphon piece in the softener compart- Only detergents, softeners and ad- ment, ditives suitable for washing ma- ) there is a liquid detergent apparatus for chines should be used. liquid detergent use in the main washing Do not use soap powder. compartment.
Using Anti-Limescale • When necessary, only use anti-limescale produced for washing machines. Using Bleach and Decolourants • Select a programme with pre-washing and add bleach at the start of pre-washing. Do not put detergent in the pre-wash com- partment. As an alternative application, se- Use of Gel and Tablet Detergents lect a programme with additional rinsing •...
It may be necessary to Powder and liquid deter- pre-treat the stains or per- gents recommended for form prewash. colours can be used at Prefer liquid deter- dosages recommended Liquid detergents Powder and liquid deter- gents produced for heavily soiled clothes. suitable for colours gents recommended for for delicate...
6.2 Symbols on the Display 1 Temperature Indicator 2 Spin Speed Indicator 3 Duration information 4 Door lock is engaged symbol 5 Programme follow-up indicator 6 No Water indicator 7 Add Garment Indicator 8 Bluetooth Connection Indicator 9 Remote Control Indicator 10 Delayed Start Enabled Indicator 11 Auxiliary Function Indicators 3 12 Child Lock Enabled symbol...
Page 23
Please read Installation section of You can see the washing duration the manual before first use. on the display of your machine while The auxiliary functions in the table selecting a programme. Depending may vary according to the model of on the amount of laundry you have your machine.
• Eco 40-60 6.4 Programme Selection In the Eco 40-60 programme, you may wash a. Determine the programme suitable for the normally soiled cotton laundry that are spe- type, quantity and soiling level of the cified to be washed together at 40°C or laundry in accordance with "Programme 60°C.
Page 25
• Hygiene+ Do not load more than 1 double fibre Applying a steam step at the beginning of duvet (200 x 200 cm). the programme allows to soften the dirt eas- Do not wash your duvets, pillows ily. and etc. that contain cotton filling in the machine.
Page 26
• Apply the pre-treatment chemical on your • StainExpert garments directly or add it together with The machine has a special stain programme the detergent in the powder detergent which enables the removal of different types compartment. Thus, you can obtain the of stains in the most effective way.
c. Read the garment tag carefully and en- Whenever a new programme is selected, the sure that correct temperature and spin recommended temperature for the pro- speed are selected. gramme appears on the temperature indic- ator. It is possible that the recommended •...
If you are not going to unload your laundry Select the desired auxiliary functions before immediately after the programme completes, starting the programme. Whenever a pro- you can use Rinse Hold function in order to gramme is selected, icons of the auxiliary prevent them from getting wrinkled when function symbol that is selected together there is no water in the machine.
While it differs with each programme, when When the Specialised Programme you press the Quick Wash button once, the auxiliary function is selected, the programme duration will drop to a certain washing performance and energy level. If you press the same button for the consumption will be different than second time, it will drop to the minimum dur- the declared value.
the machine on/off key to cancel the func- • Bluetooth tion. The programme follow-up light will re- You can use the bluetooth connection func- main on until the function is cancelled or the tion to pair your machine with your smart step is complete.
a. Open the loading door, place the laundry Programme duration may differ from and put detergent, etc. the values in section "Programme and consumption table" depending b. Select the washing programme, temper- on the water pressure, water hard- ature, spin speed and, if required, the ness and temperature, ambient tem- auxiliary functions.
c. Pull down the loading door emergency 6.11 Loading Door Lock handle with a tool and release. Then There is a locking system on the loading open the loading door. door of the machine that prevents opening d. If the loading door does not open then of the loading door in cases when the water repeat the previous step.
If the temperature of the water inside If you turn the programme selection the machine is above 50°C, you knob when the Child Lock is en- cannot deactivate the door lock for abled, the programme will not be safety reasons, even if the water cancelled.
You can touch the “Appliances” tab in the PLIANCE” (touch here for setting up a HomeWhiz application to view appliances new appliance) button in the upper right paired with your account. Following the in- corner. Perform the setup by following stallation of the application, HomeWhiz func- both the steps below and the steps in the tion enables the washing machine to send...
6.15.2 Setting up a Washing Ma- If you cannot successfully perform chine Connected to the setup within 5 minutes, your washing machine will turn off auto- Someone Else's Account matically In this case, you will have If the washing machine that you want to use to start over the setup procedure.
If the Remote Start function cannot be If the Bluetooth connection is turned turned on, you will hear a warning sound on in your product, then the Remote when you press the button. This may be ex- Control function can be selected. perienced if the appliance is turned on and If the Remote Control function can- there is no appliance paired with Bluetooth.
Drum illumination lamp of your machine will turns off. The drum illumination lamp will go light up after the programme is completed. off if you do not press any button within 10 When you turn off your machine, the lamp minutes after the programme has ended.
In addition, prior to transporting the product 7.4 Cleaning the Water Intake Fil- (e.g., when moving to another house) water ters should be drained completely. There is a filter at the end of each water in- take valve at the rear of the product and also NOTICE: at the end of each water intake hose where Foreign substances left in the pump...
• Place the end of the hose in a large con- a. Clean any residues inside the filter as well tainer. Drain the water into the container as fibres, if any, around the pump im- by pulling out the plug at the end of the peller region.
Page 40
Product stopped shortly after the pro- • Input temperature of water is low. >>> Re- gramme started. quired time to heat up the water extends in cold seasons. Also, washing time can • Machine has stopped temporarily due to be lengthened to avoid poor washing res- low voltage.
Page 41
• Excessive foam has occurred and auto- • Excessive amount of detergent is used. matic foam absorption system has been >>> Put the detergent in the correct com- activated due to too much detergent us- partment. Do not mix the bleaching agent age.
Page 42
• Draining hose is folded. >>> Check the • The detergent in the main wash compart- drain hose. ment got wet while taking in the prewash water. Holes of the detergent compart- Laundry became stiff after washing. (**) ment are blocked. >>> Check the holes •...
, might give raise to safety is- sues not attributable to support.beko.com , given in the user manual/warranty card or through your authorized dealer may and will void the warranty of the product.
Page 44
sues and damage the product and sub- sequently cause fire, flood, electrocution and serious personal injury to occur. By way of example, but not limited to, the following repairs must be addressed to au- thorized professional repairers or registered professional repairers: motor, pump as- sembly, main board, motor board, display board, heaters etc.
Need help?
Do you have a question about the B5WT594108W2 and is the answer not in the manual?
Questions and answers