FORMING FUNCTION Elevate Dual Monitor Arm 52 User Manual

FORMINGFUNCTION.SE
USER MANUAL
In order to achieve a correct mounting of Elevate Dual Monitor Arm, you
are advised to read and follow the instructions step by step. If there are
incomprehensible steps, please let us know and we will get back to you.
Note all necessary parts are found in 3 separate boxes.
STEP 1A
(FOR STANDARD CLAMP)
If you do not intend to mount the final
product to the edge of a table, then go to
Step 1B.
Position the clamp bracket in accordance
to the table thickness using the guidelines
below.
Adhere pad (B2) to the bottom side of the
clamp (B1). Fasten clamp to the table
using the handle.
ELEVATE DUAL MONITOR ARM 52
TABLE THICKNESS GUIDE
0-36 mm (upper position)
9-56 mm (lower position)
1
2
USER MANUAL
Elevate Dual Monitor Arm
PARTS AND TOOLS
A x2 PCE
B1 ×1 PCE IN DESK CLAMP
B2 ×1 PCS STANDARD CLAMP
C ×1 PCE
D ×1 PCE
E ×1 PCE
×1 PCE
F
×2 PCS
G
H ×2 PCS
MIGHT BE PRE-MOUNTED
I
×8 PCS
M4x10
J M4x10
×2 PCE
K ×1 PCE 5mm
×1 PCE 4mm
L
2mm
M ×1 PCE
N ×1 PCE
STEP 1B (FOR IN-DESK CLAMP)
Use Allen Key (L) to loosen the three
screws and remove the pre-assembled
bracket.
1
REMOVE
Adhere pad (A1) to the bottom of
3
the clamp, through the long bolt.
Insert the re-assembled clamp
through the hole in the table. Secure
the clamp using all remaining parts
F, G, E, N.
Be sure to tighten both nuts.
4385515201
ART. NO
4385515202
4385515209
52
1
Use the same three screws to fasten the
In-Desk bracket (B) and long bolt (D).
2
MOUNT
TABLE HOLE GUIDE
20-50 mm (diameter)
0-36 mm (table thickness)
If you intend to pass the
cables through the hole,
then Ø50 mm is
approprate.
FORMINGFUNCTION.SE