AICKSN MHC-RO2000G-P4-ATS4-2R+UV Manual

4. Filter element life setting mode:
Press and hold the set button for 10 seconds and when you hear three beeps, it will automatically
jump to the first level of filter life and flash. Use the + and - keys to set the filter life.
Shortly press the Set key again to jump to the secondary filter element life, and repeat the + and -
key settings.
Continue to press the Set button briefly to jump to the third-level filter life setting.
Continue to press the Set key briefly to save the settings and exit and jump to the time interface.
If the continue button is not pressed during the setting process, it will jump to the main time
interface after 30 seconds and the setting parameters will not be saved.
5. Forced flushing mode: On the time page, press and hold the reset button for 10 seconds to
force back washing.
6. Turn on the machine and back wash for 20 seconds. Back washing starts after continuously
producing water for 4 hours.
7. When the filter element age is less than 15 days, the alarm light will be on. When the filter
element age is equal to 0, the alarm light and the fault light will be on at the same time.
Trouble Shooting
NOTE: Turn off the system
PROBLEM POSSILE CAUSE
The power is not turned on
The machine does
The machine does
The high voltage switch cannot be reset
not start
not start
Transformer burns out
Pressure loss of high-pressure pump
The high-pressure
The four-sided valve is faulty and cannot enter water
pump works
(there is no pure water or waste water)
normally but cannot
produce water
The pre-filter is blocked
RO membrane is blocked
The solenoid valve fails to effectively cut off the water
The machine shuts
down but the waste
Check valve to relievepressure (waste water flow is
water does not stop
small)
High-voltage switch failure
The machine The system has pressure relief phenomenon
repeatedly jumps off
The pre-filter is blocked
after the water is full
RO membrane is blocked
The waste water ratio is too conductive
Insufficient pure
water Insufficient high-pressure pump pressure
Warranty Service
1. The warranty period starts from the date of issuing the invoice.
2. Warranty period: The whole machine is guaranteed for two years, and the consumables are not within the scope of the
warranty.
3. If the machine number is altered, the user disassembles and replaces the machine by himself or the operation not in
accordance with the instructions andall man-made damage are not covered by the warranty.
4. If your machine is abnormal, please unplug it immediately, turn off the water source and contact with local distributors.
SOLUTION
Check the power supply or the power plug
Measure its resistance after
Measure its resistance after releasing the
releasingthe pressure and
pressure and replace it
replace it
Measure its output voltage and replace it
Measure the outlet pressureof the pump
and replace it
Replace the four-sided valve
Observe the pure water and waste water,
and replace the pre-filter
Clean or replace RO membrane
Observe the waste water and change the
four-sided valve
Observe the waste water and replace the
check valve
Replace the high-voltage switch
Check the pure water pipeline after the
check valve
Replace the pre-filter
Clean or replace RO membrane
Replace waste water ratio
Measure the pump outlet pressure
MHC-RO2000G-P4-ATS4-2R+UV MANUAL
Large Flow RO System with UV Sterilization
Thank you for choosing our Reverse Osmosis Water Systems. You now
own a superb Reverse Osmosis (RO) system that adopts the international
advanced reverse osmosis membrane (RO membrane) as the core, and
with multi-stage pre-treatment filtering, the filtering accuracy reaches
0.0001 micron, effectively reducing most contaminants, organic and
inorganic compound, unwanted taste and odor from tap water. It is
designed to transform your tap water into distill water. The entire water
production process is fully automatic.
Filter Service Life
PP Cotton Filter : Recommend changing every 3~6 months.
ATS Filter: Recommend changing every 8~12 months.
RO Membrane : Recommend changing every 24~36 months.
UV Sterilizer:Recommend changing every 18~20 months.
U.S. AICKSN Technology Co.,Ltd.
Address:250 w clifton st tampa,FL.33614
Aicksn (Fujian) Environmental Protection Technology Co., Ltd
Tel:0086 0592-5776975
Fax:0086 0592-5776905
Website:www.aicksn.com