Table of Contents
Advertisement
ã=
Warning
At the end of the programme please open
the door fully and not partially
when emptying the dishwasher. Any
escaping water vapour could damage
sensitive worktops.
Interrupting the programme
– Open the door.
– Switch off the main switch (.
The LEDs go out. The programme
is saved.
If the door was opened on an
appliance which has a warm water
connection or is heated, first leave
the door ajar for several minutes
and then close. Otherwise, expansion
(pressure) may cause the appliance
door to spring open or water to run
out of the appliance.
– To continue the programme,
switch on the main switch ( again.
– Close the door.
Terminating the programme
(Reset)
– Open the door.
– Simultaneously press programme
buttons # and 3
for approx. 3 sec.
– Close the door.
The programme sequence lasts
approx. 1 min. On the digital
display @
– Open the door.
– Switch off the main switch (.
– Close the door.
is indicated.
Changing the programme
After you have switched the appliance on,
it is possible to change the programme
within 2 min.
If you want to change the programme
afterwards, the appliance waits until
the initiated programme section
(e. g. washing) ends. The remaining time
comprises the remaining time
of the previous programme section
and the remaining time of the new
selected programme.
Intensive drying
The final rinse uses a higher temperature
which improves the drying result.
The running time may increase slightly.
(Caution if utensils are delicate!)
– Open the door.
– Hold down programme button #
and press main switch (
until the digital display illuminates.
– Release both buttons.
The LED for button # flashes
and the digital display @ displays
the setting
(off) or
To change the setting:
– By pressing the # button, you can
switch intensive drying on
– Switch off the main switch (.
The set value is saved.
– Close the door.
en
(on).
or off
.
17
Advertisement
Table of Contents
