Oppermann Regelgeräte TGU 3.6 Important Notes

Important notes on installing the TGÜ / GWA 3.6.
Carefully and slowly slide the cover upward to access the device. Refasten the cover
to the housing as shown below prior to installation / wiring to prevent damage to
the data cable and the two black ground cables between the mainboard and the
display circuit board. Close and refasten the cover immediately after mounting /
wiring or prior to longer periods of disuse to prevent dirt or building site dust from
entering. Handle electronic components carefully and properly. Even if they have
passed all electrical inspections and tests, they still require proper handling. This will
help preserve the high quality and sustain the service life of your product. Thank
you for your cooperation.
Note: It is recommended to install the control unit outside the danger zone.
All rights and modifications reserved.
Screw on the cover here
prior to mounting / wiring!
Observe the data sheet and the wiring diagram
and check that the wiring is correct before
connecting the system to the power supply.
Avoid touching the circuit boards / SMD
components.
GWA TGÜ Important notes on installing | Version 03-2024 | 1 | 1