Proscend 108M Series Quick Installation Manual

108M Series Ultra-Speed VDSL2 Extender
Quick Installation Guide
Overview
Combination of any two of 108M, 108MI, and 108MI-TB
features a pair of point-to-point solutions utilizing VDSL2
technology for carrying Ethernet data over UTP cables.
Front Panel Illustration
The following interfaces are placed on the front panel:
 1 x RJ-45 connector for Gigabit Ethernet LAN port
 1 x RJ-45 connector for VDSL2 port
 3 x LEDs for LAN port speed and link status
 1 x LED for power status
 1 x LED for RT mode activation
 1 x LED for VDSL2 link status
 4 DIP Switches for CFG (Configuration)
LED Indicators
LEDs on the right
LED Color
PWR Green
RT Green
Slow: Idle
LNK Green
Fast: Training
LEDs on the left
LED Color Blink
10 Green Data Transmitting
100 Green Data Transmitting 100Mbps
1000 Green Data Transmitting 1000Mbps
DIP Switch Configuration
DIP
Function
Switch
1 RT/CO
2 Asymm/Symm Asymmetric
3
4
Note:
The factory default setting of switch 1 is "ON", other three DIP switches are at
"OFF" positions. Before adjusting the DIP switch, ensure that the power has
been turned off.
Version: 1.01
Blink On
Device
N/A Power Off
Power On
RT
N/A
(Remote) (Master)
VDSL2
LINK UP
On Off
10Mbps LINK DOWN
LINK DOWN
LINK DOWN
On Off
RT CO
Symmetric
Mode Interleave G.INP
SNR Low High
Power Connection
There are two options for power input from the rear panel.
(1) 108M/108MI: Input from DC Jack, 12 ~ 24VDC,
(2) 108MI-TB: Input from Terminal Block range 12 ~ 24VDC
Insert the positive and negative wires into V+ and V- contacts on
the terminal block and tighten the wire-clamp screws to prevent
the wires from being loosened.
LINE Port Pin Assignments
Two of the eight pins of VDSL2 port are used to connect UTP
cable over long distances, pin-out assignments are shown in the
table below.
Pin
1
Off
2
3
CO
4 ANALOG Input/Output
5 ANALOG Input/Output
VDSL2
LINK
6
DOWN
7
8
Wall Mounting
Wall mounting is only supported by 108MI and 108MI-TB.
 At the rear side, two mounting holes are placed for
horizontal or vertical wall mounting.
 The length of the screw head and body, must not be longer
than 3mm inside the device body.
-1-
Description Figure
Not Used
Not Used
Not Used
Not Used
Not Used
Not Used
P/N: 604040000081