Related Manuals for NEFF D91T7N0GB
Summary of Contents for NEFF D91T7N0GB
- Page 1 Installation instructions and how to use and look after your built-in cooker hoods D91T7 NEFF (UK) Ltd...
- Page 2 Fig. 1 Abb. 1 ELECTRO...
-
Page 3: Appliance Description
Light / fan technical measures, such as reciprocal switches interlocking, etc. If the air intake is inadequate, there is a risk of poisoning from combustion gases which are drawn back into the room. An air-intake/exhaust-air wall box by itself is no guarantee that the limiting value will not be exceeded. -
Page 4: Before Using For The First Time
Use carefully. They contain important you may find descriptions of individual information concerning your personal features that do not apply to your safety as well as on use and care of the specific appliance. appliance. This extractor hood complies with all Please retain the operating and relevant safety regulations. -
Page 5: Operating Procedure
Intensive setting: The most effective method of removing vapours produced during cooking is to: Maximum power is obtained at the intensive setting. It is only required for short Switch the ventilator ON intervals. as soon as you begin cooking. ç... -
Page 6: Filters And Maintenance
Important: By cleaning the metal grease filters at appropriate intervals, the possibility of them catching fire as a result of a build-up of heat such as occurs when deep-fat frying or roasting is taking place, is reduced. Saturation indicator: When the grease filters reach saturation... - Page 7 The activated carbon filter should risk of fire and the function of the extractor be replaced straight away. hood may be impaired. Important: Removing the filter: Change the activated carbon filter promptly...
-
Page 8: Cleaning And Care
20 Watt, G4 bulbholder). soapy solution and a soft, damp cloth only. Caution: Plug-in bulbholder. Do not use stainless-steel cleaner to clean Take hold of the bulb with a clean cloth. the operating buttons. Stainless steel surfaces: Use a mild non-abrasive stainless steel cleaner. -
Page 9: If You Encounter A Problem
Instructions). Disconnect the extractor hood from the mains electricity supply by pulling out the plug or switching it off at the main fuse box. Wait for approx. 1 minute and then switch it on again. If you have any questions or if a fault occurs, please call Customer Service. -
Page 10: Installation Instructions
Only one side of the extractor hood Please ask your dealer or inquire at your may be installed next to a high-sided unit local authority about current means of or high wall. Gap at least 50 mm. -
Page 11: Prior To Installation
flue that is as reciprocal interlocking, etc. currently used for other purposes, nor into a shaft that is used for ventilating rooms in If the air intake is inadequate, there is a which stoves or fireplaces are also located. - Page 12 Short, smooth air exhaust pipe. Mount the pipe directly onto the air As few bends in the pipe as possible. outlet on the hood. Diameter of pipe to be as large as possible and no tight bends in pipe.
-
Page 13: Electrical Connection
The electronic control system will then hold circuit. A suitable separator is a switch have been set to recirculating mode. that has a contact gap of more than 3 mm By repeating steps 1 and 2, you can and interrupts all poles. Such devices include circuit breakers and contactors. -
Page 14: Installation
430 - 710 hood on the ceiling. Circulating air 2. Using the template, mark screw 430 - 750 positions on the ceiling. 3. Drill 4x 8 mm holes and insert wall plugs flush with the ceiling. min. 550 electric 650 gas... - Page 15 8 screws. Exhaust air 430 – 710 Circulating air 430 – 750 09. Screw the extractor hood to the support frame and screw back the panel. 6. Screw the support frame to the ceiling with 4 screws. 7. Remove the panel.
- Page 16 11. Connect the pipes. screw into position. 12. Connect the power. 13. Carefully remove the protective foil. 14. Place the two sections of the upper flue on the extractor hood and clip together. Protect the extractor hood from damage. 16. Insert the two sections of the lower flue and clip together.
- Page 17 Notes...
- Page 18 Notes...
- Page 19 Z5120X5 351210...
- Page 20 NEFF (UK) Ltd. Grand Union House, Old Wolverton Road, Old Wolverton Milton Keynes, MK12 5PT Tel: 01908 328300 9000 032 337 Fax: 01908 328399 Printed in Germany 0905 Es.
Need help?
Do you have a question about the D91T7N0GB and is the answer not in the manual?
Questions and answers