Vicair iShear User Manual
  1. Manuals
  2. Brands
  3. Vicair Manuals
  4. Medical Equipment
  5. iShear
  6. User manual

Vicair iShear User Manual

Hide thumbs

Advertisement

Table of Contents

USER MANUAL
iShear

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the iShear and is the answer not in the manual?

Questions and answers

Related Manuals for Vicair iShear

Summary of Contents for Vicair iShear

  • Page 1 USER MANUAL iShear...
  • Page 2 Symbols Used in This Manual Disclaimer Precautions and Safety Instructions Product Description iShear iShear Display Before using the iShear and Display 11 Preparing the iShear Preparing the iShear Display Using the iShear Connecting the iShear with the iShear Display Placing the iShear...
  • Page 3 USER MANUAL Vicair B.V. Bruynvisweg 5 Important: Please read this manual carefully 1531 AX WORMER before using the iShear device and the iShear The Netherlands display. Website: www.ishear.com Phone: +31 (0)75 642 9999 For more information or to (re)order manuals, contact your country’s distributor.
  • Page 4 Intended Use and Reasonably requirements Foreseeable Misuse iShear device 1.7 kg / 3.75 lbs Weight The iShear is designed for clinicians such as a Display 148 gr / 0.33 lbs doctor or therapist for measuring the Total 27 × 690 × 615...
  • Page 5 TSF. Product Identification The unit in which the TSF is Force Unit The iShear device can be identified by the measured: Kilograms (Kg), sticker located on the product (see Figure 2). Newton (N) or Pounds (Lbs). The physical product, see...
  • Page 6 Vicair. The most recent Protected againtst tool, wires etc. IP31 version of this manual is available on the iShear greater than 2.5 millimeters. website: iShear.com/support. Regularly check Protected against dripping water.

  • Page 7: Precautions And Safety Instructions

    • Do not pinch or wrinkle the iShear. improper use or negligence. • Do not fold the iShear in any other way than in the way it is originally placed in the WARNING! storage case. •...

  • Page 8: Product Description

    • Make sure that the lateral flaps of the iShear parallel to the seat plane. This force occurs are not covering the top of the cushion. between the cushion and the seat base •...
  • Page 9 Figure 5, 6, 7, 8 and 9), including the sensor bar made of aluminium, sensor strips, AAA Battery compartmet for four AAA batteries batteries and iShear mat. The iShear display serves as the user interface. The mat consists of Figure 6 a low friction middle layer and a high friction top and bottom layer with lateral flaps.
  • Page 10 Measurement screen The Measurement screen serves as your iShear Display primary interface for taking measurements. The iShear display serves as the user interface Here, you can initiate and monitor the for the iShear, and has several functions: measurement process efficiently.
  • Page 11 Information on certification and manufacturer Preparing the iShear will show in a pop-up by pressing the ‘about’ To ready the iShear for use, follow these steps: button. To exit this screen press the pop-up. 1. Remove the iShear from its storage case.
  • Page 12 Align the rear end of the the iShear sensor bar and the iShear display: wheelchair seat with the rear end of the 1. Press the on/off button on the iShear (see iShear mat (see Figure 14). Section 3.2, Figure 6). A flashing blue light indicates the iShear is powered on.
  • Page 13 Figure 15 Figure 17 Figure 16 2. Tap ‘Reset’ (see Figure 16). The TSF value will be reset to 0 (Kg/N/Lbs). Figure 18 5.3.2 Single measurement To take a single measurement of TSF: 1. Allow the client to lean against the back To save the measurement: support (see Figure 17).
  • Page 14 You do not need to keep your display connected 6. Tap the empty text field ‘Note’ and fill in any or close to the iShear that is performing the Log relevant information about this session. Therefore it might be necessary to measurement or wheelchair setup.
  • Page 15 Syncing logs only works from iShear (sensor bar) to display and not from display to iShear. Log files that are saved on the iShear can be synced to any iShear display. It is advised to delete saved logs on the iShear after each session to prevent data leaks (see chapter 5.6.5).
  • Page 16 To delete a log file form the display, tap the confirmation to delete. red x in the ‘Sync Logs’ menu. This will not delete the log from the iShear (see Figure 24). Figure 22 Figure 24 5.6.5...

  • Page 17: Maintenance, Cleaning And Storage

    Daily Cleaning Clean the iShear mat daily using a damp (not wet) cloth and a mild detergent mixed with water. Gently wipe the surface to remove dirt and stains. Institutional Cleaning For institutional cleaning, employ a general disinfectant cleaner. Mild alcohol-based...
  • Page 18 Ensure the iShear device is turned off Choosing a Dry Storage Area completely before storing it. This helps Store the iShear in a dry place to prevent conserve battery life and ensures it’s ready for moisture damage. Keeping it in a dry the next use.

  • Page 19: Warranty

    Compliance with these operating provided instructions. Avoid placing any objects instructions is mandatory in order to ensure the on top of the folded iShear, ensuring it remains correct function and operation of the iShear. undisturbed during storage. This preserves its Any damage arising from abnormal use, or integrity and performance.

  • Page 20: Any Questions

    ANY QUESTIONS? Contact Vicair B.V. at info@vicair.com or contact your country’s Vicair distributor.
  • Page 24 8 717261 042749 cair B.V. uynvisweg 5 31 AX Wormer e Netherlands ww.ishear.com Vicair B.V. Bruynvisweg 5 1531 AX Wormer The Netherlands info @ vicair.com www.vicair.com shear genius.

Table of Contents