View Menu "Skyplot" Restart Mode Selection - GNS 701 StarterKit Manual

GNS 701 StarterKit

View Menu "Skyplot" restart mode selection

4.3
Four GPS/GLONASS-Core start-up modes, factory reset, cold start, warm start and hot start, are
selectable to perform receiver restarts. The start-up condition data for the GPS/GLONASS engine is
injected as referred to the following table.
S -U
TART P
M
ODE
F
ACTORY
R
ESET
C S
OLD TART
W S
ARM TART
H S
OT TART
1. Select the start condition.
2. Select the number of counts, which should be passed.
3. Click "start" button.
4. Time To First Fix (TTFF) in seconds is displayed at the "Fix time" column.
5. After finishing the cycles the results can be optionally stored in an Exel-sheet, by clicking on
the EXEL-button.
GPS/GLONASS engine starts up without Time-, Position-, Ephemeris- and
Almanac-Data and additionally all system and user configurations are erased.
GPS/GLONASS engine starts up without Time-, Position-, Ephemeris- and
Almanac-Data
GPS/GLONASS engine starts up with inaccurate Time- and Position-Data,
valid Almanac Data but without Ephemeris Data
GPS/GLONASS engine starts up with Time-, Position-, Ephemeris- and
Almanac-Data
D
ESCRIPTION
manual
14
© GNS-GmbH 2013
V 0.10, Apr. 18th 2013