Aktobis AG WDH-930EEW Manual

Building Dryer WDH-930EEW
Dear Customer,
You have chosen a high-quality product. To ensure that you get a lot of enjoyment from this product, here are a few more tips:
After transport:
Since the unit uses refrigerant, improper transport can sometimes occur despite careful instructions on the carton. Therefore, we
ask you to let it stand upright for at least 4 hours before using it for the first time so that the refrigerant in the unit can settle
properly again.
In case of any problems:
We hope that the unit meets your expectations! If, despite the greatest possible care, there should ever be cause for complaint,
please contact us briefly, as we are very concerned about your satisfaction and would like to clear up any misunderstanding.
Putting into operation:
Attention: Please check that the sealing plug (for using the collection container), which is located at the back of the unit, is
screwed on tightly !!! Otherwise, it may lead to an unwanted water leakage under your appliance.
As the internal piping is coming into contact with moisture for the first time, it may take up to approx. 3 hours for the first liquid to
accumulate in the collection container, depending on the room humidity.
Start-up time / delays:
To protect the compressor, it does not switch on again immediately after the unit has stopped operating or there has been an
interruption in operation (e.g. emptying the condensation water tank). The compressor is initially in a so-called "protection mode"
for about 3 minutes, in which only the fan runs before the compressor switches on again.
Aktobis AG, Borsigstr. 20, D-63110 Rodgau / Germany
www.AKTOBIS.de
E-Mail: info@aktobis.de