Energize Lab Eilik User Manual page 8

1.5 Reset the robot if it gets no response after an update
After resetting, a pop-up ERROR
3
interface indicates that you can
start the update again.
You need to fully format the storage
card of the robot if the reset doesn't
work. (Refer to page 29)
6
Connect the second and the third
1
FLAT metal pins on the base of the
robot with
materials.
Keep the short-circuiting state, and then plug the
2
USB cable (which needs to be connected to the
power supply) into the robot.
METAL/CONDUCTIVE
ERROR!
MISSING FIRMWARE
PLEASE CONNECT USB
TO UPDATE