Main Fuse And Fusible Link; Installation Of Accessories - Subaru Legacy 200 Owner's Manual

Maintenance and service
4. Pull out the fuse with the fuse puller.
5. Inspect the fuse. If it has blown, replace it with a spare fuse of the
same rating.
6. If the same fuse blows again, this indicates that its system has a
problem. Contact your SUBARU dealer for repairs.

Main fuse and fusible link

HB8003CB
The main fuses and fusible link are designed to melt during an overload
to prevent damage to the wiring harness and electrical equipment.
Check the main fuses and fusible link if any electrical component fails to
operate (except the starter motor) and other fuses are good. A melted
main fuse or fusible link must be replaced. Use only replacements with
the same specified rating as the melted main fuse or fusible link. If a
main fuse or fusible link blows after it is replaced, have the electrical sys-
tem checked by your nearest SUBARU dealer.

Installation of accessories

Always consult your SUBARU dealer before installing fog lights or any
other electrical equipment in your vehicle. Such accessories may cause
the electronic system to malfunction if they are incorrectly installed or if
they are not suited for the vehicle.
– CONTINUED –
11-45