— Flip Monster — CONTENTS Equipment ............2 Table of contents ..........3 Safety information .......... 4 Additional Important information ........5 informAtion can be found on the "Check it out" ASSEMBLY INSTRUCTIONS page 18 STARTING ON PAGE 6 Assembly instructions ......... 6 Commissioning ..........
— SAFETY INFORMATION INSTRUCTIONS FOR HANDLING WITH BATTERIES: WARNING › To operate the models, you will need two AAA batteries (1.5 Volt,type AAA/LR03), which could not be included in the kit due Not suitable for children to their limited shelf lifed. under three years.
Page 5
Children want to marvel, understand and create something new. They want to try everything out and explore things by themselves. They want to know more! They can do all this with our KOSMOS experimental kits. And much more than just an experiment comes of this - a strong person grows.
Page 6
Flip Flip Hooray! — Build me up! The Flip Monster can run, climb and stand up by itself if it falls down. To do this, it uses its very special drive. And that's the first thing you build! Are you ready? Then we're ready to go!
— Assembly instructions STRUCTURE OF THE FLIP MONSTER M7 x3 M7 x3 M7 x3 M7 x3 M7 x3 M7 x3 Remove all burrs. Note the correct order.
Page 8
STRUCTURE OF THE FLIP MONSTER Felt-tip pen Marking from step 10 Measure 7.5 cm Place all cables as of cable from shown. Only then insert the edge of the the printed circuit printed circuit board and the battery board and mark compartment as shown.
Page 9
— Assembly instructions Remove all burrs. 90° Insert component A9 into the recess. Remove all burrs. 180°...
Page 10
STRUCTURE OF THE FLIP MONSTER Use caution with the cables! Tilt the lid to lock it in place.
Page 11
— Assembly instructions Remove all burrs. 90° 180° Turn the parts as shown.
Page 12
STRUCTURE OF THE FLIP MONSTER Remove all burrs. Note the order in which Top view they are put together.
Page 13
— Assembly instructions Note the order in which Top view they are put together. Place Place as shown as shown Left leg Right leg module module...
Page 14
STRUCTURE OF THE FLIP MONSTER Left leg module Right leg module Left leg module Right leg module Richtig Done...
— Commissioning INSTALLATION OF THE BATTERIES Inserting, removing and changing batteries should be done by adults or under adult supervision. Batteries are to be inserted with the correct polarity (+ and -). Press them gently into the battery compartments. Please observe the further notes on the correct handling of batteries on page 4. Make sure that the switch is set to O, which means OFF.
Page 16
HANDLING AND CHALLENGES Step 1 Slide the controller to I to switch on the robot. Step 2 To switch it off again, either wait until the gearbox is back in the middle between the legs, or proceed as follows: Wait until the gearbox has moved to the very end.
— Challenges Level Your Flip Monster can also climb stairs. Test how high your robot gets. Flip Monster with a twist When the gearbox has reached the end of the rail, place your finger on the other end and press it gently downwards.
Page 18
CHECK IT OUT the funCtional principlE Flip Monster of your Your Flip Monster and a conventional scale have more in common than you might think. This is because both work according to a similar principle: leverage. The best way to explain this is with a see-saw on the playground.
Need help?
Do you have a question about the Flip-Monster and is the answer not in the manual?
Questions and answers