Page 1
Manual SCAN Français – Italiano QR CODE Español – Nederlands Česky – Slovensky TO DOWNLOAD Polski – Magyar FULL-COLOUR Български – Русский MANUAL ... and more or go to: www.kosmos.de/int/Solar-System Solar – System —EQUIPMENT — You will also need: Diagonal pliers (alternatively scissors and a nail file) Bezeichnung Anzahl Art.-Nr.
Page 3
— ASSEMBLY Stecke die Sonnenachse bis zum Anschlag ein. Push the sun axis (F6) in as far as it will go. Turn it clockwise 90 degrees. Drehe sie dann um 90 Grad im Uhrzeigersinn. Locked 90° 90° gesperrt...
Page 4
Pay attention to the orientation of the disk. Seitenansicht Side View Drehe die obere Scheibe um Rotate the upper disk 90 degrees 90 Grad, bis diese einrastet. clockwise to lock it in place. 90° gesperrt Locked Fest Press it zusammen- all the way on.
Page 5
— ASSEMBLY Test the device: Turn the dial (C28) Dreiecke nach oben. Triangles upwards. counterclockwise a few clicks and let go. If all the disks rotate as the motor runs, it is properly assembled. If not, disassemble and go back through the assembly steps.
Page 6
Insert the ends of the rods into the holes. Nutze die Abbildung links, Use the rod sizing guide to the left to um die Stäbe richtig zuzuordnen. determine which rod is which. With your sun, the holes will certainly not be in a row as shown.
Page 7
You built an orrery! An orrery is a mechanical model of the solar system (or of just the Sun, Earth, and Moon) that shows the relative position and motion of the planets around the Sun.
For every 7 rotations of the dial the following ring turns ... Your solar system model only has one motor. So how does it ... 3.5 times. make the planet models revolve at four different speeds? ... 2.3 times.