Do you have a question about the K3026SS and is the answer not in the manual?
Questions and answers
Stephanie
March 20, 2025
My machine keeps cutting off automatically after running and make a small amount of ice. Right before it's cuts off, all of the lights turn on at once and then shuts off. The power button, start ice button, clean button and even the 3 little lights will all turn on for a quick second then the machine will shut off.
1 comments:
Mr. Anderson
March 20, 2025
The Personal Chiller K3026SS could automatically shut off after making a small amount of ice if the ICE BIN indicator is lit, signaling that the bin is full. To restart ice making, press the SOFT ICE button twice. Additionally, if the water reservoir is overfilled or the water inlet is clogged, it may affect operation. Ensuring the drain plug is securely in place and maintaining proper cleaning can also help prevent shutdowns.
This answer is automatically generated
Alex
March 17, 2025
What does it mean both of the buttons of ice machine doesn’t do its function. It won’t make ice and it won’t clean the machine but when pressing soft ice it releases a water cycle. And the buttons don’t light up
1 comments:
Mr. Anderson
March 17, 2025
If the buttons on the Personal Chiller K3026SS ice machine do not function, do not make ice, do not clean the machine, and do not light up, check the following:
1. Ensure the unit is plugged into a working 120V, 60Hz power outlet. 2. Confirm that the power outlet is properly grounded and meets electrical code requirements. 3. Verify that the power button has been pressed to turn on the appliance. 4. Avoid using an adapter or extension cord, as this may cause power issues. 5. Inspect the power cord to ensure it is not damaged or disconnected.
If the issue persists after these checks, the unit may require further troubleshooting or service.
This answer is automatically generated
Alex
March 16, 2025
What should I do when the machine has water but the no water button is blinking. And it won’t start to make ice or clean when pressing the buttons
1 comments:
Mr. Anderson
March 16, 2025
If the Personal Chiller K3026SS has water but the "ADD WATER" indicator is blinking and it won't start making ice or clean, follow these steps:
1. Stop the ice maker. 2. Refill the water tank if necessary. 3. Press and hold the CLEAN CYCLE button for 3 seconds to restart the cleaning cycle. 4. If the issue persists, ensure the unit is properly drained and refilled. 5. Check if there is too much ice in the bin; remove excess ice if needed. 6. Restart the unit and try again.
This answer is automatically generated
Vanessa Rose
June 13, 2025
My Ice Maker not making Ice anymore
Heather Michael
February 18, 2025
Wont make ice after being cleaned with vinager
1 comments:
Mr. Anderson
February 18, 2025
The Personal Chiller K3026SS may not make ice after being cleaned with vinegar if there is still vinegar residue in the system. The manual recommends using a 1:1 vinegar/water solution every 3-4 weeks with the cleaning cycle. If not properly rinsed, vinegar may interfere with ice production. To resolve this, drain and replace the water, then run a cleaning cycle with fresh water to remove any remaining vinegar.
Page 1
SOFT NUGGET ICE MAKER Model K3026SS USER GUIDE...
Page 2
It is not crushed ice or shaved ice, it the perfect small pellet ice for crunching and munching! Your Personal Chiller Soft Nugget Ice Maker is desired by soft ice lovers everywhere with ice made fast and ready anytime for personal enjoyment or entertaining guests.
IMPORTANT: LET THE UNIT REST AND REMAIN UNPLUGGED FOR 24 HOURS BEFORE USE. SAFETY PRECAUTIONS 4" Use a grounded Ensure 4” clearance from rear Keep hands and objects 3-prong outlet only clear of ice outlet of unit when placed against wall No Sharp Knife No location near Indoor Use Only...
SAFETY INSTRUCTIONS • Do not, under any circumstances, alter or remove the third (ground) prong from ATTENTION! Some types of under-cabinet lamps can be the power cord. For personal safety, this product must be properly grounded. hot enough to cause damage to your machine top’s appearance. •...
Page 5
CAUTION To reduce the risk of injury when using machine, follow the basic safety precautions: • Do not remove any safety, warning, or product information labels from your ice maker. • Lifting Hazard: It is recommended to have two people move and install the ice maker in order to prevent injury.
Control Panel What’s Inside Personal Chiller Soft Nugget Ice Maker, Ice Bin, Ice Scoop, Quick Start Guide, User Guide and Customer Review Card LOCATION OF CONTROLS Power Button: Press button once to turn on the appliance. Soft Ice Button: Press button once, to start making ice.
Page 7
IMPORTANT! OPERATING INSTRUCTIONS FLUSH SYSTEM BEFORE FIRST USE After cleaning and ushing for initial use, locate the appliance on a stable Step counter top or at surface with a minimum of 4” of space all around the unit, FIRST USE The ice maker must stand upright for 24 hours including the back of the unit for proper ventilation.
FLUSHING THE UNIT Draining Water from Ice Maker Step Before ushing and draining, unplug unit. Step Place the front left edge of unit over a sink, or bucket. Step Position unit next to sink or bucket where ready to empty water into a sink, or bucket.
CARE & CLEANING For initial use and regular maintenance unplug this unit and follow these cleaning instructions. Wipe exterior of the ice maker and the interior of the ice bin When nished, after 3 minutes, the Clean Cycle will automatically stop with a soft damp cloth and wipe dry to avoid any deposits.
ICE MAKER SOUNDS TROUBLESHOOTING Your Personal Chiller Soft Nugget Ice Maker is not like an OBSERVATION POSSIBLE CAUSE SOLUTION ordinary hard ice machine. There are several processes “ADD WATER” • Lack of water • Stop the ice maker, ll water, and press required to create light, airy soft-textured ice.
Page 11
TERMS AND CONDITIONS Limited End User Warranty THIS WARRANTY IS GIVEN IN LIEU OF ALL OTHER EXPRESS WARRANTIES. Kell Electronic USA, Inc., (the “Company”) warrants that their products (the “Product”) are free of IMPLIED WARRANTIES, STATUTORY OR OTHERWISE, INCLUDING BUT NOT defects in material and workmanship for a period of ONE YEAR (the “Warranty Period”) from the LIMITED TO ANY IMPLIED WARRANTIES OF MERCHANTABILITY OR FITNESS FOR date of purchase by end user.
Need help?
Do you have a question about the K3026SS and is the answer not in the manual?
Questions and answers
My machine keeps cutting off automatically after running and make a small amount of ice. Right before it's cuts off, all of the lights turn on at once and then shuts off. The power button, start ice button, clean button and even the 3 little lights will all turn on for a quick second then the machine will shut off.
The Personal Chiller K3026SS could automatically shut off after making a small amount of ice if the ICE BIN indicator is lit, signaling that the bin is full. To restart ice making, press the SOFT ICE button twice. Additionally, if the water reservoir is overfilled or the water inlet is clogged, it may affect operation. Ensuring the drain plug is securely in place and maintaining proper cleaning can also help prevent shutdowns.
This answer is automatically generated
What does it mean both of the buttons of ice machine doesn’t do its function. It won’t make ice and it won’t clean the machine but when pressing soft ice it releases a water cycle. And the buttons don’t light up
If the buttons on the Personal Chiller K3026SS ice machine do not function, do not make ice, do not clean the machine, and do not light up, check the following:
1. Ensure the unit is plugged into a working 120V, 60Hz power outlet.
2. Confirm that the power outlet is properly grounded and meets electrical code requirements.
3. Verify that the power button has been pressed to turn on the appliance.
4. Avoid using an adapter or extension cord, as this may cause power issues.
5. Inspect the power cord to ensure it is not damaged or disconnected.
If the issue persists after these checks, the unit may require further troubleshooting or service.
This answer is automatically generated
What should I do when the machine has water but the no water button is blinking. And it won’t start to make ice or clean when pressing the buttons
If the Personal Chiller K3026SS has water but the "ADD WATER" indicator is blinking and it won't start making ice or clean, follow these steps:
1. Stop the ice maker.
2. Refill the water tank if necessary.
3. Press and hold the CLEAN CYCLE button for 3 seconds to restart the cleaning cycle.
4. If the issue persists, ensure the unit is properly drained and refilled.
5. Check if there is too much ice in the bin; remove excess ice if needed.
6. Restart the unit and try again.
This answer is automatically generated
My Ice Maker not making Ice anymore
Wont make ice after being cleaned with vinager
The Personal Chiller K3026SS may not make ice after being cleaned with vinegar if there is still vinegar residue in the system. The manual recommends using a 1:1 vinegar/water solution every 3-4 weeks with the cleaning cycle. If not properly rinsed, vinegar may interfere with ice production. To resolve this, drain and replace the water, then run a cleaning cycle with fresh water to remove any remaining vinegar.
This answer is automatically generated