VivaQuant Rhythm Express RX-1 mini Use Manual page 9

Changing Electrodes
Change electrodes as instructed by clinic staff.
To remove electrodes, gently grasp the edge/tab and peel back in a slow, continuous
motion. A wet, warm washcloth may aid in removal of the electrodes. To avoid skin
damage, do not rapidly remove the electrodes.
Note: To avoid excessive skin irritation, we suggest that when you change electrodes, place
them next to the prior location. Place each electrode just to the side, above, or below
where it was before. Never reuse electrodes. If an electrode is misplaced or not applied
correctly, discard it and use a new electrode.
— Connecting Your Device for the First Time —
Starting a Recording (done only once)
Press Red button on the device for 5 seconds until you feel device buzz. The device will
start recording within 10 seconds.
To confirm that the device is recording, briefly press the Red button (less than 1 second).
The heart icon will blink green in groups of three.
Recording When you Travel
The RX-1 mini device will record data continuously and keep time according to your home
location registered with your physician. Even if you travel across time zones, data will
always be recorded and time stamped based on your home location provided that you
keep your device charged. If you travel outside the U.S. data will still be recorded, but it will
not be sent to the monitoring center until you return to the U.S.
Recording Symptoms
When you feel symptoms that your physician asked you to record, press and hold the Red
button on the device for 3 seconds until you feel the device buzz.
NOTE: For a period of 3 minutes following recording of a symptom, the RX-1 mini will
not allow a new symptom to be recorded.
8
Rhythm Express® RX-1 mini Patient Use Guide LP-015 Rev J