Page 1
Co., Ltd. assumes no responsibility for injuries or property damage resulting from failures arising out of improper installation or operation inconsistent with this documentation or through use of parts other than this product, such as locally procured parts.
Page 2
Caution: Notice: • Before attempting to connect or operate • This product is not suitable for use in loca- this product, please read these instruc- tions where children are likely to be pres- tions carefully. ent. • Do not install this product in locations where ordinary persons can easily reach.
ø161 mm (W) x 115 mm (H) {ø6-11/32 inches x 4-17/32 inches (H) } Approx. 700 g {1.55 lbs} Mass: Finish: Aluminum die cast Heavy salt damage prevention coating , i-PRO white QSR506S Others: Heavy salt damage prevention (ISO14993-compliant) QSR506S...
Precautions for installation In order to prevent injury, this product must be securely mounted to a bracket according to Installation Guide. Mounting method for this product This product is designed to be used as a pendant mount camera. If it is mounted on a desk- top or at a slant, the camera may not work correctly and its lifetime may be shortened.
Installation Step 1 Step 2 Step 4 QSR506 QSR506F QSR506M QSR506F1 QSR506M1 Step 3 Step 1 WV-QCL501/ WV-QCL501S Check of combination of brackets WV-QWL501/ WV-QWL501S • Brackets with normal specification QSR506 + WV-QCL501 (Ceiling mount bracket) + WV-QWL501 (Wall mount bracket) •...
Page 6
• Securely fasten when fixing this product. Step 3 (Due to the thread of the fastening section, this product’s fixing position is not consistent.) Safety wire (locally procured) ① ③ ② 140 mm {5-1/2 inches} Safety wire (locally procured) Installed auxiliary wire QSR506F QSR506F1 QSR506M QSR506M1 Safety wire...
Page 7
Hereafter, illustrations are created using WV-QSR506F installation as an Step 4 example. Also, cables and safety wire may be omitted. ② ① • Do not loosen the fixing scews more than four turns. Depending on the installation location, if it is difficult to adjust the angle of view with Step 5 the camera front installation setting below, align the camera front (▼...
Page 8
Step 6 ① ③ QSR506F QSR506F1 QSR506M QSR506M1 Safety wire Installed auxiliary wire (locally procured) Safety wire Recommended (locally procured) tightening torque: ② 0.78 N·m {0.58 lbf·ft} • Tighten the nut until the bracket is fixed. Step7 Follow the installation procedure described in the installation guide of the camera for the subsequent procedures.
Need help?
Do you have a question about the WV-QSR506 and is the answer not in the manual?
Questions and answers