Tacony Truvox imop Lite Original Instructions Manual

Commercial floor cleaning machine

Advertisement

ORIGINAL INSTRUCTIONS
CAUTION – READ THESE INSTRUCTIONS BEFORE USING THE MACHINE
imop Lite
Commercial Floor Cleaning Machine
USER MANUAL
EN
www.truvox.com
03-8583-0000
Issue 1 (10-23)

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Truvox imop Lite and is the answer not in the manual?

Questions and answers

Summary of Contents for Tacony Truvox imop Lite

  • Page 1 ORIGINAL INSTRUCTIONS CAUTION – READ THESE INSTRUCTIONS BEFORE USING THE MACHINE imop Lite Commercial Floor Cleaning Machine USER MANUAL www.truvox.com 03-8583-0000 Issue 1 (10-23)
  • Page 2: Ec Declaration Of Conformity

    EC DECLARATION OF CONFORMITY EN (English) Machine Type: Floor cleaning machine Model: IMOPLITE… This machine is in conformity with the following EU directives: • Machinery Directive: 2006/42/EC The EMC Directive: 2014/30/EU • Applied harmonised standards: BS/EN60335-1, BS/EN60335-2-72, BS/EN55014-1, BS/EN55014-2, BS/EN61000-3-2, BS/EN61000-3-3, BS/EN62233, Truvox International Limited, Unit C (East),Hamilton Business Park, Manaton Way Malcolm Eneas, Operations Director Botley Road, Hedge End, Southampton, SO30 2JR, UK...
  • Page 3 EN (English) IMPORTANT - BEFORE USE READ THESE INSTRUCTIONS AND RETAIN FOR FUTURE REFERENCE INTRODUCTION The following instructions contain important information about the machine and safety advice for the operator. Equipment must be operated, serviced, and maintained in accordance with the manufacturer’s instructions. If in doubt, contact the supplier of your machine.
  • Page 4: Important Safety Advice

    IMPORTANT SAFETY ADVICE The safety information described in this manual provides basic precautions and supplements standards in force in the country where the machine is used. This symbol warns the operator of hazards and unsafe practices which could result in severe personal injury or death. WARNING –...
  • Page 5 34. DO NOT kink or twist the power cord and keep cord away from heated surfaces. 35. Unless charging, the plug of the charger power cord must be removed from the socket-outlet when not in use and before commencing cleaning of the machine or undertaking maintenance operations. 36.
  • Page 6 Attaching the brushes Fig. 1 To attach the brushes: Put the i-mop®Lite in store position, see section ‘STORAGE’. Hold the scrub deck firmly with one hand. Align the left brush (Fig. 1 pos. 1) with the left motor disk (Fig. 1, pos. 2). Align the latches and cut-outs in the brush and moto disk.
  • Page 7 Installing the cleaning solution tank The tanks on the i-mop Lite use an anti-bacterial mix-in to make the plastic safer both inside and outside. Because it is mixed into the plastic, the effect will last the lifetime of the tank. Always keep the anti-bacterial tanks of the i-mop Lite out of direct sunlight.
  • Page 8: Working Mode

    Filling the cleaning solution tank Ensure the body of the i-mop Lite is in an upright position when filling the tank Remove the cap on the tank. Pour in a maximum of 0.79 gal/ 3 L of cleaning fluid. Replace cap and make sure it seals tightly. Put the i-mop®...
  • Page 9 Stand behind the i-mop®Lite. Choose your cleaning mode via the buttons on the control panel (Fig.8, pos 1 to 4). You can select the options independently or combined. Hold the handle with both hands. Squeeze the trigger on the handle (Fig.8, pos 5). This will also start the i-mop®...
  • Page 10 ECO mode The ECO mode will use 40% less cleaning solution. Turn on the ECO mode by pushing the ECO button (Fig. 11, pos 1). Turn off ECO mode by pushing the ECO mode again. To start normal cleaning mode push button (Figure 11, pos2) Fig.
  • Page 11: Brush Replacement

    Cleaning the filter Fig 14 Put the i-mop® Lite in store position, see section ‘STORAGE’ Remove the recovery tank. Release the blue suction filter (Figure 14, pos 1) from beneath the rubber holder by tilting it slightly and pulling it out. Clean the filter.
  • Page 12: Squeegee Replacement

    Fig. 16 SQUEEGEE REPLACEMENT Detaching the squeegee Put the i-mop®Lite in store position, see section 4.2. Hold the scrub deck firmly with one hand. Pull on the left side of the squeegee (Figure 17, pos 1) to remove it. Pull on the right side of the squeegee to remove it. Remove the vacuum hose from the squeegee by twisting the hose Flipping/replacing the squeegee blade Unscrew the 6 plastic nuts on the back.
  • Page 13 Fig. 18 Transporting in a vehicle The preferred way to transport the i-mop Lite is in an upright position and safely secured. • • Both tanks should be emptied The battery removed • The seal of the solution and recovery tank can be damaged during transport in horizontal position, make sure you remove the tanks before loading the machine into your car.
  • Page 14: Maintenance

    MAINTENANCE WARNING - Before undertaking maintenance operations or adjustments switch off machine and remove the battery. CAUTION – Always keep the body of the i-mop Lite in the stored position when replacing the brushes or the squeegee IMPORTANT – All other servicing and repairs should only be performed by a Truvox engineer or Authorised Service Agent. IMPORTANT –...
  • Page 15: Fault Diagnosis

    RECOMMENDED SPARES & ACCESSORIES Description i-mop i-dose 3/5/7 Mixed 10ML (120pcs) 86-0000-0000 i-mop i-dose 3 Sanitary Pink 10ML(120pcs) 86-0001-0000 i-mop i-dose 5 Daily Blue 10ML (120pcs) 86-0002-0000 i-mop i-dose 7 Degreasing Green 10ML(120pcs) 86-0003-0000 i-mop Lite Squeegee Kit Front Primothane (10pcs) 86-0004-0000 i-mop Lite Squeegee Kit Rear Primothane (10pcs) 86-0005-0000...
  • Page 16 (10-23)

Table of Contents