Download Print this page

Associated 6033 Operator's Manual

Heavy load electronic battery tester

Advertisement

Quick Links

HEAVY LOAD ELECTRONIC BATTERY TESTER
SAFETY INFORMATION
Working in the vicinity of lead-acid battery is DANGEROUS due to EXPLOSIVE GASES
generated by the battery, these gases can be ignited by a spark, cigarette or flame and
are powerful enough to blow a battery apart, forcefully showering the area with battery
pieces and acid.
To reduce the chance of exploding batteries follow instructions by manufacturers of
batteries as well as these instructions.
IN CASE OF ACCIDENT RINSE EYES WITH CLEAN WATER AT LEAST 5 MINUTES
AND SEEK MEDICAL ATTENTION IMMEDIATELY. NEVER USE EYE DROPS OR
OTHER MEDICATION UNLESS DIRECTED BY A DOCTOR.
When working around lead-acid batteries wear eye protection. NEVER smoke, have an
open flame or sparks near battery. Have plenty of ventilation and keep your face as far
as possible from the battery. Undercharged lead-acid batteries will freeze during cold
weather. Never test or charge a frozen battery. Do not allow tools to drop onto a
battery. Do not lay tester on battery.
BATTERY LOAD TEST
This test evaluates the battery's ability to crank an engine. The tester draws current
from the battery while measuring its voltage level. The voltage level of a good battery
will remain relatively steady under load, but a defective battery will show a rapid loss in
voltage.
Battery size (CCA rating) and temperature will affect test results - follow
instructions carefully.
1.
Turn off engine, accessories and battery test equipment.
OPERATOR'S MANUAL
WARNING
Batteries produce explosive gases and can explode.
Wear safety goggles. (User and bystanders)
Keep flames and sparks away from batteries.
Read and follow instructions.
Battery explosion and ignited gases can cause injury.
WARNING
Battery acid can cause chemical burns.
Wear protective clothing. (User and bystanders)
Chemical burns can cause injury.
MODEL 6033

Advertisement

loading
Need help?

Need help?

Do you have a question about the 6033 and is the answer not in the manual?

Questions and answers

Summary of Contents for Associated 6033

  • Page 1 MODEL 6033 HEAVY LOAD ELECTRONIC BATTERY TESTER OPERATOR'S MANUAL WARNING Batteries produce explosive gases and can explode. Wear safety goggles. (User and bystanders) Keep flames and sparks away from batteries. Read and follow instructions. Battery explosion and ignited gases can cause injury.
  • Page 2 NOTE: The 6033 tester uses the battery under test for power. If the battery voltage is less than 7.5 volts, the display will not come on. If when connecting the tester, the display does not light up, check for correct polarity hookup. If correct, charge the battery and try again.
  • Page 3 ENGINE SHOULD BE AT NORMAL OPERATING TEMPERATURE Turn off all lights and accessories. Operate engine at fast idle (approximately 1500 RPM). Connect tester clamps to battery as described in Step 2 under Battery Load Test. NOTE: If the tester is still connected to the battery from a previous test, it is necessary to disconnect one of the clamps to reset the tester before performing another test.