Usage Instructions - VEVOR WY-890 Instruction Manual

3. About 5 minutes later, when the lamp keeps on, it means the setting
temperature was reached and automatic sealing operation can be performed. Only
can use it by manual sealing operation if the setting temperature is not reached.
4. Selection of cup and sealing film
a. Easy ripping film is suitable for sealing the cup of a variety of materials.
b. In other cases, the materials of cup must be same as the film. Such as the
cup of PP (Polypropylene) must be used with the film of PP.
c. the recommended temperature refers to the Parameter form.
5.Switch off the power after finishing the sealing, and the lower mould will go in
automatically, then take the plug out.
6. In case there is an accident, never put your hand into the machine when it is
working.

Usage instructions

Begin sealing the cup when completing above preparation:
1.Press the button of auto operation, light is on.
2.Put the cup filled liquid into the down plate, then it is sent into the machine by
pulling-plate. Do not seal empty cup for testing cause the light cup will be
adsorbed on the heating plate and stick the film.
3.The machine will automatically roll the firm, seal the cup, cut the film and output
the cup plate, and then the counter displayer will count the quantity.
4.Take out the cup and finish one operation.
Please confirm that the space between two color patches of the film is no
less than 115 mm.
Attention
1.In order to protect the electric system of the machine, don't rinse it by water;
only clean it with cloth and cleaning liquid which contains no corrosive
components.
2. Please turn off the machine when the operator is absent .
3.In case there is a short circuit or fault, please plug off the machine and request
qualified people to repair it.
4. In case of repair, please ask for an expert and use the original spare part.
- 8 -