Parkside KH 1500 PATIO-HEATER Manual page 9

• Do not stand the appliance directly under a lug socket.
• Never use the appliance with timer automatic switches e.g. timer switches, which automatically switch the
appliance on as accidental covering of the appliance could lead to a fire risk.
• The appliance may only be connected to an extension cable, which is suitable for an output of 1.500 Watts.
• Do not cover the appliance and do not place anything over or on top of the appliance. Keep a distance of at least
50 cm to all flammable objects. There is a fire risk!
• Do not touch the front side of the heating element, the metal casing or the two handles on the front side during
and shortly after use. These parts become very hot. Danger of being burnt!
• Never clean the appliance with easily flammable cleaning agents as for example Petrol or Spirit.
• When connected to the mains, only move the appliance using the handle on the backside of the heating element.
Only move the appliance when it is switched off and has cooled.
• Do not allow hair or clothing to get too near the appliance when in use.
• Never submerge the appliance, the power cable or the plug in water.
• If a problem occurs while in use or while cleaning, first unplug the appliance. Allow the appliance to cool before
cleaning.
• Unplug the appliance when not in use.
• When unplugging the appliance, always pull by the plug not the cable.
• Repairs must be carried out by qualified experts only to avoid danger or accident. This also applies to the changing
of the mains power cable. In the case of unqualified repair being carried out, the guarantee becomes void.
• The floor heater is intended for domestic use only, not for commercial use.
• If the appliance is passed on to someone else, include these instructions for use. Only in this way can the next
person use the appliance safely.
G
ETTING STARTED
Assembling the appliance
• Lay the heating element (3) with the stand carefully on the
floor, with the heating rods facing downwards.
• Lay the bottom end of the stand into the half of the base,
which has a pin on the inside. The pin should thereby be
stuck into the upper hole of the stand.
• Lay the second half of the base stand on the first half and
press until the two halves click together.
• Stick the provided nut on the one side into the hole in the
base and screw everything together with the bolt.
• Turn the heating element up to the label in a horizontal position.
Now your floor heater is ready for use.
Pin
9