Sennheiser SR 2000 IEM Instruction Manual page 18

Easy Setup Sync
Place the infra-red interface of the diver-
sity receiver in front of the infra-red
interfaces of the remaining transmitters,
one after the other.
Store the frequency bank and channel
setting by pressing the jog dial on your
transmitters. You can carry out the
function (see right-hand column) at a
later time to establish a transmission link
between transmitters and receivers.
OR:
Immediately synchronize your receivers
with your transmitters by carrying out the
Sync function (see right-hand column).
This establishes a transmission link
between transmitters and receivers.
The icon in the left lower corner of
the transmitter display indicates that the
Sync function can be carried out.
–
Sync
–
–
Sync
To cancel the transfer:
Press the STANDBY
mitter.
" " appears on the display panel of the
transmitter. " " also appears if no suit-
able receiver was found.
Using the transmitter
button on the trans-
17