Advertisement
Quick Links
Installation Instruction
Wooden Cold Plunge Tub
READ ALL INSTRUCTIONS BEFORE UNPACKING THE PRODUCT
INSTRUCTIONS THAT, IF IGNORED, COULD RESULT IN DEATH OR SERIOUS INJURY CAUSED BY INCORRECT HANDLING
OR INSTALLATION OF THE PRODUCT. THESE INSTRUCTIONS MUST BE OBSERVED FOR SAFE INSTALLATION.
This product must be installed by a fully insured and licensed bathtub installer. For chiller maintenance, troubleshoo�ng, or
refrigerant refill, please hire a licensed HAVC installer. This product uses R410A refrigerant.
We are not responsible for local code compliance for this product. Building and plumbing codes may vary from state-to-
state in accordance to your loca�on. We are not responsible for providing any compliance cer�fica�ons.
Under no circumstances we are liable for any and all incidental damages sustained in connec�on with this product. Neither
manufacturer, distributor or retailer is responsible for water damage or flood caused by the usage of this product.
Under no circumstances we are liable for any and all fees, cost of installa�on/reinstalla�on/removal, subsequent damages
or transporta�on in case of the product defect.
The connection instructions in this manual are for general reference. The actual connections may varyby the type of cold
plunge tubs you purchase.
2 PEOPLE ARE REQUIRED TO LIFT AND DURING
TWO PEOPLE
LIFT REQUIRED
ENTIRE INSTALLATION OF THIS PRODUCT
www.woodbridgebath.com
Model: WIC54-01
1
Advertisement
Subscribe to Our Youtube Channel
Related Manuals for Woodbridge WIC54-01
Summary of Contents for Woodbridge WIC54-01
- Page 1 Installation Instruction Wooden Cold Plunge Tub Model: WIC54-01 READ ALL INSTRUCTIONS BEFORE UNPACKING THE PRODUCT INSTRUCTIONS THAT, IF IGNORED, COULD RESULT IN DEATH OR SERIOUS INJURY CAUSED BY INCORRECT HANDLING OR INSTALLATION OF THE PRODUCT. THESE INSTRUCTIONS MUST BE OBSERVED FOR SAFE INSTALLATION.
- Page 2 1.Precau�ons for use Before use ① Ensure the power source matches the rated voltage of the chiller, which is 110-120V. ② The power switch should be set at 1.4 meter or higher, so children cannot reach it. ③ Please fill up the tub to above the minimum water level line before use (higher than the water inlet and outlet). In use ①...
- Page 3 3.Product informa�on Product Name: Wooden Cold Plunge Tub Model:WIC54-01 28-3/8 32-5/8 Size:(L)54″ x (W) ″ x (H) ″ / 166.4gal Water Volume:630L Capacity:1 person Material:Thermo rubber wood 18-3/4ʺ 19ʺ *Since the wooden barrel is purely handmade, the product size will be with a reasonable tolerance. Please refer to the actual size.
- Page 4 Accesories in Tub package: ●Insulated Tub Cover*1 ● Stepping Stool*1 ●Backrest*1 ●Tub Inlet Filter Screen(built-in) ●Tub Drain Stopper*1 ●Wooden Tub Repair Kit*1 ●Black Hard Hose*2 Accesories in Chiller package: ●Chiller ●Quick connector*4 ●Chiller Water Drainage Tube*1 (Separate Installa�on Instruc�on) ●GFCI Plug ●Wheel*4 ●Filter Container Wrench*1 11.5cm...
-
Page 5: Working Principle
4.Working principle The chiller cools down the water with the compressor inside. Then, the water circulates back to the wooden tub to lower the temperature of the tub water. In certain models, the chiller can also warm up the water with its built-in heater. Water Circula�on: Wooden Tub ->... - Page 6 Chiller power distribu�on ① Please take safety precau�ons before powering any connec�ons. ② Connec�on or replacement of wiring should comply with electrical specifica�ons and should be performed byrofessionals. ③ Make sure the chiller voltage is consistent with the local supply voltage. The chiller is 110-120V. 6.Cold Plunge Usage ①...
- Page 7 ③ Water filling ④ Use a water hose to inject water DIRECTLY into the tub Start to fill water into the cold plunge with a water hose; water inlet. Bubbles will be flushed out from the tub Con�nue to inject water so that the water level is higher water outlet.
- Page 8 7.Technical Specifica�on Cold plunge Parameters 54ʺ x 28-3/8ʺ x 32-5/8ʺ 630L / 166.4gal Thermo rubber wood FAQ: ① Why do wooden tub leak a�er not being used for a period of �me? Due to the natural characteris�cs of solid wood, if it is not used for a long �me or due to temperature changes, it will cause the wood to expand and contract due to heat and cold, resul�ng in small leaks at the bo�om.
- Page 9 ⑦ Following these steps should help you fix leaks in your tub effec�vely. Remember to allow sufficient �me for the glued area to dry before using the tub again. If the issue persists a�er following these steps, it is advisable to reach out to WOODBRIDGE Customer Service for addi�onal assistance.
-
Page 10: Warranty
Improper care and use of abrasive cleaners and will void the warranty. During this limited warranty period if a malfunction occurs and after inspection it is determined that a defect developed during normal use, Woodbridge will as at... - Page 11 DO NOT USE: Abrasive sponges or cloth. Never use steel, wool, or wired brushes that will permanently scratch the Retain these installation instructions for future reference! Thank you for using WOODBRIDGE products! WOODBRIDGE California (Norwalk)Distribu�on Center 15600 Blackburn Ave,Norwalk,CA 90650 New Jersey (Somerset)Distribu�on Center...
- Page 12 www.woodbridgebath.com...
Need help?
Do you have a question about the WIC54-01 and is the answer not in the manual?
Questions and answers