Flyduino KISS ESC 50A Manual page 2

• Super fast speed acceptance
• Precise speed acceptance
• Active "free-spinning" (very low diode losses)
• Regenerative braking (Active Braking)
• Supports 3-6S Lipo
• 100-2400, Oneshot42, Oneshot125 as well as (25 – 500Hz) PWM with automatic
detection
• Supports the following protocols: FrSky Sbus, Graupner SumD, TBS CROSSFIRE
and Multiplex SRXL as well as the following telemetry protocols; S-Port, Graupner
HOTT, TBS CROSSFIRE and Sensorbus
ESC Connection Assignment
• Brushless Motor Connections (3)
• Lipo Connection +
• Lipo Connection - (GND)
• Signal/Telemetry/Ground Connection (GND)/FC + Connection as 8-Pin JST Socket
• Telemetry Signal (KISS TLM / SPort / CRSF TX / HOTT / Sensorbus)
• PWM/Dshot Signal Input (PWM / OS128 / OS42 / DSHOT 600-2400)
• FC Connection - (GND)
• FC Connection + (Lipo Voltage)
Changing the Motor Rotation Direction
The KISS FCs as well as Betaflight FCs support the change of the rotation direction via the GUI.
KISS ESC - Serial Receiver
Describes how the KISS ESC is connected directly to a serial receiver output (SBUS, Graupner
SUMD, Multiplex SRXL or TBS CRSF receiver). This function is only supported by KISS ESC
25A and KISS ESC 32A! The KISS ESCs support direct connection to a serial receiver. The input
signal is automatically detected. Since the ESC does not supply 5V to the receiver, it must be
supplied separately! The output of a telemetry protocol is separately adjustable with PWM signal
input. More information can be found in the description.
FrSky SBUS and S-Port
Connect the Sbus output with Sig. | RX-Pin. And if you need telemetry, connect S-Port with TLM |
TX. If a valid Sbus signal is detected, S-Port is automatically activated. The ESC uses Sbus channel
0 as standard throttle channel. This can be changed in the CLI interface. For S-Port, its standard
sensor address is 27. It can be changed in the CLI interface. Available telemetry: Voltage (Volts),
Current (Amps), Consumption (mA/h) - Temperature (°C), RPM (standard for 14-pole magnet
motor, configurable in the CLI).
Graupner SumD
Connect the SumD output with Sig. | RX-Pin. And if you need telemetry, connect HOTT with TLM
| TX. If a valid SumD signal is detected, HOTT is automatically activated. The ESC uses SumD
channel 0 as standard throttle channel. This can be changed in the CLI interface. In the HOTT
telemetry, it is found as Electric Air Module. Available telemetry: Voltage (Volts), Current (Amps),
Consumption (mA/h) - Temperature (°C), RPM (standard for 14-pole magnet motor, configurable in