Flyduino KISS ESC 50A Manual

KISS ESC 50A 4-in-1
Welcome to the KISS ESC 50A 4-in-1 Product Description
Safety Instructions
• Due to the "regenerative braking" functionality, a KISS ESC should only be operated with
batteries. A power supply could be damaged by the returning current. The ESCs themselves
are protected.
• Never start a motor while holding it in your hands!
• Never grab into rotating propellers! When starting the engines with mounted propellers, a
sufficient safety distance must be maintained!
• Never touch the ESCs during operation or shortly afterwards! The KISS ESCs can reach a
temperature of up to 80°C!
• The ESC must never be powered while soldering!
• The electronic components of the ESC are sensitive to static charge. Please ensure
appropriate safety precautions, such as sufficient grounding of the workplace and body
grounding (grounding bracelet).
Technical Data
• Technical Specifications
• 32-bit ARM Cortex M4 MCU
• Operating voltage 6 - 26V / 2-6S Lipo
• When using 5-6S, a low ESR capacitor of at least 470μF is required, ideally 1000μF
and at least 35V, ideally 50V
• Maximum continuous current output 50A per individual ESC, actively limited
• Maximum rotational error speed 600000 ERPM (we recommend 500000 ERPM)
• Dimensions 40 x 45mm
• Hole spacing 30.5mm
• Hole size 3.2mm
• Hardware/Feature Specifications
• Telemetry-capable (voltage, current, temperature, RPM)
• Active current limitation (constant current measurement and limitation at 50A
maximum)
• Active temperature monitoring (actively reduces performance from 100°C)
• Sinwave/BackEMF Hybrid conversion for cleaner running
• 2400 (Full resolution of 2000 steps requires only 6.5µs)
• Supports all common Dshot commands such as Turtle Mode, 3D Mode and direction
change
• Advanced adaptive auto-timing (3.25-30° adjustment with each conversion)
• Built for race quads (50A per individual ESC continuous load possible even with
weak cooling)
• High maximum speed! (500,000ERpm, 71,400Rpm with a 14 pole motor)
• Accurate speed control (2000 steps with DShot)
• No additional capacitors needed for 2-4S