Page 1
Failure to do so could result in serious injury. This manual should remain with the product. Specifications, descriptions and illustrations in this manual are as accurate as known at the time of publication, but are subject to change without notice. 4870-M-OP REV 20240409 Champion Power Equipment, Inc.
201371 - 1100 Lb. (500 kg) PORTAbLE WiNch iNTRODUcTiON SAfETY DEfiNiTiONS Congratulations on your purchase of a Champion Power The purpose of safety symbols is to attract your Equipment (CPE) product. CPE designs, builds, and attention to possible dangers. The safety symbols, and...
SAfETY iNSTRUcTiONS 201371 - 1100 Lb. (500 kg) PORTAbLE WiNch iMPORTANT SAfETY cAUTiON iNSTRUcTiONS Always use a winch hook strap when handling the hook for spooling or unspooling the cable/rope. WARNiNg cAUTiON Cancer and Reproductive Harm –...
SAfETY iNSTRUcTiONS 201371 - 1100 Lb. (500 kg) PORTAbLE WiNch Operation Symbols GROUND FAULT CIRCUIT INTERRUPTER PROTECTION This winch is provided with a ground fault circuit Some of the following symbols may be used on this interrupter (GFCI) built into the plug of the power supply product.
AND fEATURES 201371 - 1100 Lb. (500 kg) PORTAbLE WiNch cONTROLS AND fEATURES Read this operator’s manual before operating your winch. Familiarize yourself with the location and function of the controls and features. Save this manual for future reference.
AND fEATURES 201371 - 1100 Lb. (500 kg) PORTAbLE WiNch Parts included Assembly Parts Torque Part Hardware Part Hardware Tool(s) Needed lbf-ft (N.m) Winch Carrying Case D-Shackles Tree Savers Clevis Hook Needle nose pliers Hexagon Head Bolt 57.5-76.7 1x 19mm wrench or socket...
ASSEMbLY 201371 - 1100 Lb. (500 kg) PORTAbLE WiNch ASSEMbLY OPERATiON Assembling the Winch WARNiNg Insert M12×65 bolt through the channel hole below Read and understand this operator’s manual before the EMERGENCY STOP button and assemble with operating your winch.
Page 9
OPERATiON 201371 - 1100 Lb. (500 kg) PORTAbLE WiNch 5. Operate winch by pressing “OUT” for at least 5 WARNiNg seconds to release cable (or 3 ft. (1 m) of cable/ To reduce the risk of electrocution, keep all rope has extended from drum).
OPERATiON 201371 - 1100 Lb. (500 kg) PORTAbLE WiNch Self Recovery Locate a suitable anchor such as a strong tree trunk or LOAD boulder. Always use a sling as an anchor point. +11.7 ft. (3.6 m) WARNiNg Never spool out past the red paint on wire rope.
OPERATiON 201371 - 1100 Lb. (500 kg) PORTAbLE WiNch supply cord. This device provides additional Single Line protection from the risk of electric shock. Plug into a 120V AC circuit and press RESET. H. Drape a blanket or jacket over the cable/rope approximately 5 to 6 feet from the hook.
SUggESTED AccESSORiES 201371 - 1100 Lb. (500 kg) PORTAbLE WiNch Gloves (included) U. Keep your hands clear of the winch and hawse as the cable/rope is being drawn in. A good pair of gloves are essential for working with steel Secure the clevis hook and hook strap.
Page 13
MAiNTENANcE 201371 - 1100 Lb. (500 kg) PORTAbLE WiNch Disassemble the gearbox cover with hex key by 4. Reinstall the cable/rope tensioner to the main body, removing M5 x 30 hex head bolts (6). note the direction of the tensioner.
MAiNTENANcE 201371 - 1100 Lb. (500 kg) PORTAbLE WiNch Reassemble gear box assembly and cover with the Make sure the red EMERGENCY STOP is in the gearbox M6 x 25 screws (3). “STOP” position or pressed in. Press 2. Plug in the GFCI power supply cord and press the 8.
Page 15
MAiNTENANcE 201371 - 1100 Lb. (500 kg) PORTAbLE WiNch 4b. Winch will retract cable/rope until the cable hook stopper contacts the hawse. Once winch has stopped, the system reset is complete. 5. Confirm operation by pressing “OUT” for 10 seconds, then bringing the cable/rope back in with “IN”.
TROUbLEShOOTiNg 201371 - 1100 Lb. (500 kg) PORTAbLE WiNch TROUbLEShOOTiNg Problem Cause Solution Power not connected. Plug in power supply. Rotate the Emergency Stop Button Emergency Stop Button is OFF. clockwise until the button pops OUT to activate or start the winch.
Page 18
Consequential Damage Please register within ten (10) days from date of purchase. Champion Power Equipment disclaims any obligation to cover any loss of time, use of this product, freight, or any Repair/Replacement Warranty incidental or consequential claim by anyone from using CPE warrants to the original purchaser that the this product.
Need help?
Do you have a question about the 201371 and is the answer not in the manual?
Questions and answers