Subscribe to Our Youtube Channel
Related Manuals for AEG GDG961AB
Summary of Contents for AEG GDG961AB
- Page 1 EN User Manual | Cooker Hood GDG961AB GDG966AB GDG969AB aeg.com\register...
-
Page 2: Table Of Contents
Welcome to AEG! Thank you for choosing our appliance. Get usage advice, brochures, trouble shooter, service and repair information: www.aeg.com/support Subject to change without notice. CONTENTS 1. SAFETY INFORMATION AND INSTALLATION..........2 2. PRODUCT DESCRIPTION................2 3. DAILY USE......................3 4. CARE AND CLEANING.................. 7 5. -
Page 3: Daily Use
Function Description Third speed / Boost function The motor switches to third speed level. Press and hold for 2 seconds to activate the Boost function. Second press turns off the appliance. AutoSense Activates and deactivates the AutoSense function. Breeze The hood operates on the lowest speed. After 60 minutes the motor turns off. - Page 4 3.4 AutoSense 1. Press the button to change the colour temperature from neutral, through warm The function automatically adjusts the fan to cold. speed level basing on the TVOC sensor (Total Volatile Organic Compounds), air 2. Press and hold the button to move temperature, and relative humidity coming smoothly between light colour...
- Page 5 3.6 Filter notification CAUTION! The filter alarm serves as a reminder to clean This function is sensitive to cleaning the grease filter and either replace or clean agents. After cleaning, wait at least half the charcoal filter, depending on its type. The an hour before turning on the function to indicator blinks regularly for 30...
- Page 6 3.7 AutoSense filter notification • Wireless network with the Internet connection, Filter alarm reminds to clean the AutoSense • Mobile device connected to your wireless filter. The indicators blink regularly network. for 30 seconds if the filter must be cleaned. Frequency/Protocol WiFi: 2.4 GHz / 802.11 Refer to Care and cleaning chapter.
-
Page 7: Care And Cleaning
buttons. The indicators blink twice and the indicator turns off. If the onboarding process exceeds 1 minute, the control panel enters standby To enable the WiFi connection again, mode, the indicator turns off, and the press and hold buttons, app provides feedback on the onboarding indicators blink once. - Page 8 4.3 Replacing the charcoal filter Before carrying out any maintenance, WARNING! make sure there is no cookware on the The charcoal filter is non-washable! hob and that the hood and the hob are disconnected from the power supply. To replace the filter: 1.
-
Page 9: Troubleshooting
2. Turn the filter clockwise (1) and then pull 3. Wash the filter in hot water without using (2). detergent. 4. To install the filter back, perform the steps in reverse order. CAUTION! The filter has to be fully dried before installing it back into the appliance. -
Page 10: Environmental Concerns
Problem Possible cause Remedy The function is permanently Activate the function. Refer to the Auto‐ indicator blinks rapidly deactivated. Sense in "Daily use" chapter. three times, and the AutoSense function does not start. There is a malfunction. Contact an Authorised Service Centre. indicator blinks rapidly for three seconds, and the AutoSense function does not start. - Page 12 The software in this product contains components that are based on free and open source software. AEG gratefully acknowledges the contributions of the open software and robotics communities to the development project. To access the source code of these free and open source software components whose license conditions require publishing, and to see their full copyright information and applicable license terms, please visit: http://aeg.opensoftwarerepository.com (folder NIUS)
Need help?
Do you have a question about the GDG961AB and is the answer not in the manual?
Questions and answers