Download Print this page

Brickhouse Security VizTrack Dual-View Quick Start Manual

Download this manual

VizTrack Dual-View Quick Start Guide

Step 1: Determining Mount Position

This is a sticker-mounted dual camera and it must be mounted in the exact center of the windshield (same

distance from the left and right).

Make sure you don't put it so low that you can see too much of the vehicle hood in the picture

Make sure it cannot be blocked if the Visor is down.

Make sure that the wipers will not block the vision path when they are off

Make sure that the wipers will clean its vision path when it is raining.

Clean the spot where you will install it with an alcohol wipe and let it dry before aﬃxing it with the 3M tape.

Measure the exact center of the windshield and make a mark there.

Please read all steps BEFORE mounting the camera!

Need help?

Do you have a question about the VizTrack Dual-View and is the answer not in the manual?

Page 1 VizTrack Dual-View Quick Start Guide Step 1: Determining Mount Position This is a sticker-mounted dual camera and it must be mounted in the exact center of the windshield (same distance from the left and right). Make sure you don’t put it so low that you can see too much of the vehicle hood in the picture Make sure it cannot be blocked if the Visor is down.
Page 2 Step 2: Attach Mounting Plate to Dash Cam Take the adjusting bolt and nut and the Dashcam and swivel mount out of the packaging. See pictures below. You will notice that on one side of the swivel mount, there is a plastic gear. Fit the swivel mount into the dash cam mount slot, so that the plastic gear is on the same side as the plastic gear on the dash cam itself.
Page 3 -Using a level, draw a horizontal line with a felt pen to use to align the top edge of the camera. It's critical that this camera is level and once the 3M tape sticks to the window, you will not be able to move it. Having an alignment line to mark where you want to stick the camera will help ensure that it is installed level.