Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Cete Automotive MLB-evo
Summary of Contents for Cete Automotive MLB-evo
- Page 1 Installation Manual Drive Select Memory Module Start&Stop Memory Module MLB-evo with Touchbutton Audi A6 / S6 / RS6 C8 Audi A7 / S7 / RS7 C8 Cete Automotive GmbH – Heidekoppel 16 – 24558 Henstedt-Ulzburg – info@Active-Sound.eu...
-
Page 2: Table Of Contents
Safety Instruction ............................3 General Information ........................... 3 Place of installation ............................ 4 Audi A6 / A7 C8 ..........................4 Electronical Installation ..........................6 Activation & Deactivation (Workshop Mode) ....................8 Cete Automotive GmbH – Heidekoppel 16 – 24558 Henstedt-Ulzburg – info@Active-Sound.eu... -
Page 3: Disclaimer
The use of content takes place at the user‘s own risk. Therefore we - the Cete Automotive GmbH - assume no liability and responsibility for damages and defects, which arise from operation or incorrect handling and maintenance. -
Page 4: Place Of Installation
Step 3) Now you need a small tool to lift the small cover, with that cover lifted you are able to remove the complete isofix holder from the seat. Cete Automotive GmbH – Heidekoppel 16 – 24558 Henstedt-Ulzburg – info@Active-Sound.eu... - Page 5 Please lift the rear seat on the marked positions, it is simply clipped in. Take care of connected wires, disconnect them before you remove the rear seats. Please locate the gateway, it is in the centre of the seats. Cete Automotive GmbH – Heidekoppel 16 – 24558 Henstedt-Ulzburg – info@Active-Sound.eu...
-
Page 6: Electronical Installation
It is not enough to simply press them by fingers, please use a tool to have them fully fixed. Step 3) Connect our Orange/Black with the car’s purple. Step 4) Connect our Orange/Brown with the car’s Orange/Brown. Cete Automotive GmbH – Heidekoppel 16 – 24558 Henstedt-Ulzburg – info@Active-Sound.eu... - Page 7 Connect all connectors and do a quick check before you assemble all back. The module comes deactivated; you need to activate it by the original button, mentioned in the next chapter. Cete Automotive GmbH – Heidekoppel 16 – 24558 Henstedt-Ulzburg – info@Active-Sound.eu...
-
Page 8: Activation & Deactivation (Workshop Mode)
A 2nd possibility to bypass the module is by simply unplug it from the connector. You can keep the harness installed, if you just unplug the module, it will not memorize the function anymore and all will operate as factory. Cete Automotive GmbH – Heidekoppel 16 – 24558 Henstedt-Ulzburg – info@Active-Sound.eu...
Need help?
Do you have a question about the MLB-evo and is the answer not in the manual?
Questions and answers