Festive Lights SL221 Manual

Solar Water Feature
SL221 & SL222
These instructions contain important information which is required when using this product for the first
time. Please ensure you read all the following information carefully before first use. Please retain this
information for future reference.
Note:
1. Charge the pump unit for a minimum of 1-2 days before the pump is used for the first time.
2. The LED lights will only work when it is dark. To test them during the day, turn the solar
panel upside down and minimize exposure to sunlight.
3. The LED lights have been pre-assembled in the fountain body and cannot be removed.
1 OVERVIEW
1.1 The solar powered pump is designed for use with the accompanying fountain only. For outdoor
use only. In order to make the pump work, the solar panel requires direct sunlight. When there is
sufficient sunlight, the pump will start to work automatically when switched on. It will stop
working when the solar panel does not get sufficient light. If the fountain is used in the evening,
the built-in LEDs will automatically light up to enhance the water feature.
1.2 This solar panel contains a battery pack. When the battery pack is charged it will be used to run
the pump and LEDs when there is insufficient sunlight. It can be switched on and off using the
switch on the back of the solar panel.
2 ASSEMBLING AND USING YOUR PRODUCT
2.1 Carefully remove all of the components out of the packaging.
2.2 Fill the fountain with clean tap water.
2.3 Place the pump into the reservoir ensuring that it is fully submerged under the water.
2.4 Connect the cable from the pump to the cable at the back of the solar panel, ensuring the
connection is secure and tightly fastened by hand.
2.5 Place the solar panel in an area where the maximum amount of sunlight is possible.
2.6 Press the on/off switch on the back of the solar panel to turn the pump on.
3 WARNING
• For decorative purposes only.
• Keep out of reach of children and animals. Risk of strangulation.
• Keep away from sources of heat.
• Check regularly for signs of wear and tear, discontinue use immediately if damaged.
• Dispose of product accordingly. Individual LED bulbs cannot be replaced.
• Do not allow the pump to run dry.
• Do not lift the pump with the power cord.
• For technical advice consult Festive Light Ltd.
4 OPERATING INSTRUCTION
Turn on the solar mode: for first time to use, slide the switch to turn the pump on, the pump will
run automatically if there is sufficient light. The pump will stop working when light becomes
limited, and the battery is full drained, it will automatically begin operating again the next day
once it is in direct sunlight (solar mode). For general daily use, it is recommended to check the
fountain daily for debris which may damage the pump.