Festive Lights SL218 Manual

Solar Water Feature
SL218
Outdoor use
These instructions contain important information which is required when using this product for the first
time. Please ensure you read all the following information carefully before first use. Please retain this
information for future reference.
Note:
1. Charge the pump unit for a minimum of 1-2 days before the pump is used for the first time.
2. The LED lights will only work when it is dark. To test them during the day, turn the solar
panel upside down and minimize exposure to sunlight.
3. The LED lights have been pre-assembled in the fountain body and cannot be removed.
1

OVERVIEW

1.1 The solar pump is designed for use with the accompanying fountain only. For outdoor use only. In
order to make the solar pump work, the solar panel requires direct sunlight. When there is sufficient
sunlight, the solar pump will start to work automatically. It will stop working when the solar panel does
not get sufficient light. If the fountain is used in the evening, the built-in LEDs will automatically light up
to enhance the water feature.
1.2 This solar panel contains a battery pack. When the battery pack is charged it will be used to run
the pump and LEDs when there is insufficient sunlight. It can be switched on and off using the switch on
the back of the solar panel.
2

ASSEMBLING AND USING YOUR PRODUCT

2.1 Carefully remove all of the components out of
the packaging.
2.2 Fill the fountain with clean tap water.
2.3 Place the pump into the reservoir ensuring that
it is fully submerged under the water.
2.4 Connect the cable from the pump to the back of
the solar panel, ensuring the connection is secure and
tightly fastened.
2.5 Connect the LED light cable to the female
socket, attached to pump. Ensure the connection
is secure and tightly fastened.
2.6 Place the solar panel in an area where the maxi-
mum amount of sunlight is possible.
2.7 Press the on/off switch on the back of the solar
panel to turn the pump on.
3 WARNING
• For decorative purposes only.
• Keep out of reach of children and animals.
Risk of strangulation.
• Keep away from sources of heat.
• Check regularly for signs of wear and tear,
discontinue use immediately if damaged.
• Dispose of product accordingly. Individual LED
bulbs cannot be replaced.
• Do not allow the pump to run dry.
• Do not lift the pump with the power cord.
• For technical advice consult Festive Light Ltd.
Assemblée