Introduction Dear customer! Thank you for buying one of our products. You can find all the information you need in these operating instructions. Please read the instructions completely with care and observe the advice given. The operating instruction is part of the item and should be kept intact.
Properties Double insulation. (Stage II) CAT II In accordance with the IEC-61010-1 standard Overvoltage (installation) level II, pollution degree 2, CAT II designates the existing degree of protection against surge voltage. Corresponds to EC(EU) standard. Electrical grounding. Tools may in principle only be used for the purpose intended, under the conditions envisaged and within the limitations as to their use.
Page 4
4. LCD full display symbol Symbol Explanation DC voltage AC voltage Auto shutdown function indication Low battery indication Diode mode Continuity Capacitance Duty ratio Data hold Voltage unit: volt, millivolt Capacitance unit Resistance unit Non-contact voltage induction Live wire check Frequency unit celsius/fahrenheit 5.
Page 5
Technical index Test conditions: environmental temperature 18 °C to 28 °C, relative humidity <80%RH. 1. DC voltage Range Resolution Accuracy 0V~620V (DC mode) 0.001V ±(0.5% +3counts) 0.8V~620V (Auto mode) Input impedance: 10MΩ Maximum input voltage : 620V DC&AC ( RMS ) 2.
Page 6
6. Operation Instructions 1. Press for 2 seconds to power on, Enter AUTO mode (Auto mode can automatically measure AC voltage, DC voltage and resistance). 2. Connect the test leads to the voltage or resistance, Meter automatically measure AC voltage, DC voltage and resistance, And will display AC voltage frequency.
Page 7
AC voltage and frequency Manual mode Resistance Automatic mode Resistance Manual mode Measure Continuity Automatic mode Measure Continuity Manual mode) Capacitance...
Diode Non-contact voltage induction Live wire check 7. Maintenance 1. General maintenance Clean the meter casing regularly. Do not clean with chemical solvents. • Keep the meter input jack dry and clean. • If the meter is abnormal, please stop using it and return it for calibration and maintenance. 2.
Page 9
Also defects in tools caused by the use of accessory parts or other parts that are not KS Tools original parts. Tools which have been modified or equipped with additions.
Need help?
Do you have a question about the 150.1765 and is the answer not in the manual?
Questions and answers