Sennheiser HDE 1030 Instructions For Use Manual page 7

Putting the receiver into operation
Insert accuplug
Select receiver channel
(Only for two or three-channel receivers.)
Turn the receiver on and adjust the volume
After use
If you are not going to use the HDE 1030 for
a period, please switch it off by turning the
volume control off until it clicks
Changing the identification markers
To easily distinguish between receivers that
have been set to different frequencies a set of
colour-coded identification markers KEN
1030 can be used for labelling the different
frequencies.
Since the markers are inserted into the front
of the receiver, the different frequencies can
be clearly recognized even from a distance.
This is especially advantageous when it comes
to sorting the receivers after an event.
Fault finding
Hissing noise only
Sound is distorted
No sound at all
.
.
.
Transmitter is
switched off
Accuplug is discharged,
please replace or recharge
Accuplug is defective
or transmission is
disturbed
.
KEN 1030
7