Advertisement
Quick Links
ULB38
Rear Window Lineum Phantom
IMPORTANT:
Please read all of the following instructions before installing your new warning light.
Please Note: These instructions are provided as a general guideline only.
vehicles may require special mounting, wiring, and/or weather-sealing. This is the
sole responsibility of the installer. Star Safety Technologies assumes no responsibility
for the integrity of the installation for this or any of its products.
455 Rochester Street
585-226-9500
www.StarSafetyTechnologies.com
Some
Avon, NY 14414
(F) 888-478-2797
PLIT537 REV. D
1. The typical mounting area for this light is along the top moulding inside the rear hatch.
2. Alternately the light can be mounted to the trim above the window, on the rear hatch
itself.
3/14/24
Mounting Instructions
-1-
Advertisement
Subscribe to Our Youtube Channel
Related Manuals for Grote STAR ULB38
Summary of Contents for Grote STAR ULB38
- Page 1 Mounting Instructions ULB38 1. The typical mounting area for this light is along the top moulding inside the rear hatch. Rear Window Lineum Phantom IMPORTANT: Please read all of the following instructions before installing your new warning light. Please Note: These instructions are provided as a general guideline only. Some vehicles may require special mounting, wiring, and/or weather-sealing.
- Page 2 (Mounting CONT’D) Wiring For proper installation and full operability, this light requires a 20A ignition switched power 3. Attach the mounting brackets to the back source, connections to the negative terminal of the battery, and 4-6 external switches rated of the light. Leave the screws loose to for a minimum 1A (user supplied).
-
Page 3: Pattern Programming
Programming (CONT'D) Programming (CONT'D) There are three DIP switches, two push-buttons, and a telephone-style jack that are used to Pattern Programming set any of these options. Not only does this light have several Patterns to select from, but it also incorporates advanced programming that allows you to select which heads flash On and Off with one another (Phase), and which heads are active in any of the functions (Head Enable). - Page 4 Programming (CONT'D) Programming (CONT'D) Cruise Mode (cannot be used with Dim Option) Head Enable This light has the option of allowing you to use the Green w/Red wire to activate Cruise This light also has the ability for the installer to select which heads are active for any given Mode.
-
Page 5: Factory Default Settings
Programming (CONT'D) Programming (CONT'D) Pattern Cycling of Simultaneous Functions This section is OPTIONAL. ‘Pattern Cycling of Simultaneous Functions’ refers to how the Factory Default Settings light reacts if you activate more than one function at the same time. To reset the light to all of the factory default settings, proceed as follows: This light is programmed such that if you activate one of the Traffic Directing patterns (Left, 1. - Page 6 Operating Instructions Service Main control of this light is done though the wires in the harness. They should be connected to +12VDC through several switches (user supplied) as described in the Wiring section. These lights use state-of-the-art Light Emitting Diode (LED) technology. These NOTE: RED MUST BE CONNECTED TO POWER BLACK MUST BE CONNECTED TO GROUND...
Need help?
Do you have a question about the STAR ULB38 and is the answer not in the manual?
Questions and answers