Rocky's EAZY ROLLERS PERMANENT 4A Instructions Manual

This box contains the
following items:
RE-
ITEM QTY. DESCRIPTION ORDER #
#
1 12 Self-tapping Screw 501
5 2 5/16"x1" Bolt 505
3/8"x1" Bolt
7 4 507
15 4 Concrete Anchor 515
19 2 5/16" Washer 505
3/8" Washer
21 4 21
57 2 #4 A-Frame 531
61 1 White Knob 533
2 3" Hub
69 543
71 1 Small Handle 545
101 10 Male Grommet 549
103 10 Female Grommet 549
Plastic Bushing
105 2 555
107 2 Plastic Washer 555
201 1 22' Strapping 587
Tools Required:
Reversible Drill
1/2" Concrete (masonary) Drill Bit
Hammer & Center Punch (or nail)
5/16" Hex Head Socket Bit
1/2" Wrench
9/16" Wrench
T9605074
A
ROCKY'S EAZY ROLLERS INSTRUCTIONS - #4A PERMANENT
1 Assemble adjustable tubes
according to "adjustable tube
instructions" included in tubing
box.
Insert a 3" hub (item # 69) into one end of the
adjustable tubing.
69
SMALLER DIAMETER TUBE
With 2 self-drill/tapping
screws (item #1), attach hub
SELF-
to tube using electric drill.
DRILLING
Apply pressure to
1
ensure screw cuts into
aluminum tube then
cuts it's own thread.
(No predrilling required)
Repeat with other side.
4
3
For regular shaped pools, align
the outside edge of the tube
parallel with the end of the pool.
For irregular shaped pools, the
outside edge of the tube
Using the two holes of the #4 A-frame (item #57)
should be 3'
as guides, make two marks on deck for each #4 A-
i n s i d e
frame. With a 1/2" concrete drill bit, drill a 1 1/2"
from the
deep hole at each mark.
end of
the pool.
®
2
107
57
NOTE: APPLY PETROLEUM
BASED GREASE. 105
69
5
tap it into the the hole with a hammer.
Then using a center punch or large
nail drive the slug down into the
anchor forcing legs out into concrete.
1/16"
Bolt the castors (item #209) to the A-frames
(item #55), as shown in the diagram.
5
19
71
Assemble one end unit to the tube, using
the small handle (item #71), as shown in
the diagram.
Assemble the other end unit to the tube,
using the white knob (item #61).
For smoother operation, apply
petroleum based grease between the
hub (item #65) and the black bushing
(item #105). This should be done once a
year.
61
Position the assembled roller unit at the
widest end of the pool.
V E R Y I M P O R T A N T
PREVENT DROWNING
Attach Warning Label to one end of tube.
6
Drive the concrete anchor into
the hole with a hammer. Leave
the anchor raised 1/16".
To set the concrete anchor
3/8" washers (item #21), through
the #4 A-frames (item #57) and
into the concrete anchors (item
#15).
Tighten the 3/8" bolts.
Hit center slug
with hammer &
Slug
center punch,or
large nail.
15
7
Insert the 3/8" bolts
(item #7) through the
21