Identifying Receivers Using The "Wireless Systems Manager" Software (Identifying Function) - Sennheiser EM 3731-II - 09-09 Instruction Manual

Using the receiver
save
digital audio
processing
sync
esc
sync
< 5cm
SKM 5200-II
clock
save
6.000 M
H
z
sync
.01 BANK
AF COM
esc
CH
6
22
Position the transmitter's infra-red interface at a max. distance of 5 cm
in front of the infra-red interface (sync) A.
The transfer starts automatically. During the transfer, the two blue
LEDs in the infra-red interface (sync)
RF %
A B
the sync button
300
PEA
100 10
30
5
– After successful completion of the synchronization, the two blue
10
V 1
LEDs in the infra-red interface (sync)
9
sync button
are now also set on the transmitter and the transmission link is ready
for operation.
– If an error occurred during synchronization (e.g. the transmitter is
too far away from the receiver), the two blue LEDs in the infra-red
interface (sync)
red.
The infra-red interface of the SKM 5200-II hand-held transmitter is
located at the left-hand margin of the display. Position the
transmitter's infra-red interface precisely in front of the receiver's
infra-red interface (sync) A.
Identifying receivers using the "Wireless Systems
Manager" software (identifying function)
In multi-channel operation, it can be useful to identify the individual
channels of the receivers via the "Wireless Systems Manager" software.
The identifying function shows you which channel is assigned to which
receiver.
Start the identifying function as described in the instruction manual of
the "Wireless Systems Manger" software.
"Identified" appears on the status display of the identified receiver:
Identified
After 60 seconds, the text disappears and the current status display is
shown again.
To change to the current status display before the end of the 60 seconds:
button 6.
Press the esc
A
flash and the backlighting of
9
flashes green.
is backlit in green. The receiver's frequency and name
A
stop flashing and the
A
stop flashing and the
9
sync button is backlit in