Related Manuals for Wolverine Airsoft STORM CATEGORY 5
Summary of Contents for Wolverine Airsoft STORM CATEGORY 5
- Page 1 Page 1 OWNER’S MANUAL WOLVERINE AIRSOFT www.wolverineairsoft.com www.wolverineairsoft.com...
-
Page 2: Table Of Contents
Getting Started General Use Maintenance Disassembly / Reassembly Exploded View Don’t Forget to Register Your Warranty! Your STORM Category 5 regulator is backed by Wolverine Airsoft’s limited warranty. Scan the QR code or visit www.wolverineairsoft.com/ warranty to read our full war- ranty and register your STORM Category 5 regulator. -
Page 3: Important Safety Notices
Always be sure that your tank and tank regulator is in good working order before use with the Wolverine Airsoft STORM Category 5 regulator. In particular, ensure that all threaded components of... -
Page 4: Getting Started
Page 4 Getting Started The Wolverine Airsoft STORM Category 5 is intended for use with standard pressure or low pressure paintball HPA tanks. Pressure is adjusted by turning the set screw on the front of the regulator using the included 3/32” hex key. -
Page 5: General Use
Page 5 General Use Installation Lightly coat the threads on the tank with a silicone-based lubricant and thread the regulator onto the top of your HPA tank. Screw the regulator all the way down until it stops. The final ½-¾ turn will open the valve on the tank regulator to pressurize the system. - Page 6 Page 6 Tuning Increase Adjust the pressure on the tank by using pressure the included 3/32” hex key to turn the small set screw on the front of the regulator. The regulator is not self-venting so you will need to have the gun connected and fire the gun when adjusting the pressure Decrease lower before the gauge will show the new...
-
Page 7: Maintenance
Page 7 Maintenance Your CAT5 regulator contains high precision hardened steel internals for maximum perfor- mance. To prevent corrosion and ensure uninterrupted performance it is recommended to give a brief spray of silicone based lubricant into the vent hole every few uses or before extended storage. - Page 8 Page 8 Use the 3/32” hex key to turn the pressure adjustment screw clockwise until it is inserted fully into the regulator cap and allows the internals to drop freely. After removing the internals, remove the pressure adjustment screw. You will insert this from the outside during reassembly.
-
Page 9: Exploded View
Page 9 Exploded View Gauge 1/8” MPT Connector Vent Hole Pressure adjustment screw Reg Cap Locking Screw x4 Piston 1.5 x 19mm O-Ring Shim *Your regulator may or may not Spring require a shim. Washer Orientation Spring Washers Adjustable Spring Base Adjustment 1.5 x 8mm Spacer... - Page 10 Need professional help? To find a retailer close to you visit: www.wolverineairsoft.com/dealers www.wolverineairsoft.com...
Need help?
Do you have a question about the STORM CATEGORY 5 and is the answer not in the manual?
Questions and answers