ABB Stanilite ECOEXITBLADE Installation Manual

—
ABB Australia Pty Limited
For enquiries
ABB contact centre: 1800 60 20 20
E-mail: AU-ABB-Stanilite@abb.com
www.stanilite.com.au
© Copyright 2022 ABB. All rights reserved.
—
I N S TA L L AT I O N M A N U A L
Stanilite®
Surface Mount kit for ECOEXITBLADE
Thank you for choosing ABB product
Please read this document thoroughly before
commencing installation and retain for future
reference. The installation instructions were
correct at the time of print. To reflect changes in
technology and Australian standards; ABB reserves
the right to amend the instructions without notice.
Updated document can be found on the Stanilite
website.
Safety warning
In Australia and New Zealand, only licensed
electricians are permitted by law to work with 240
volt electrical installations. Do not attempt to
install or connect this product unless you are a
licensed electrician. Turn off and isolate the
electrical supply before connecting this fitting to
the building wires. Do not touch the terminals of
the terminal block when the light fitting is
energized. The only user serviceable part is the
battery pack. The LED light source is not user
serviceable. Do not attempt to service other parts
of the fitting as this will void the warranty. As the
installer, it is your responsibility to ensure
compliance with all relevant building and safety
This document covers What's inside the box
Safety warning
Sufface Mount Kit
Testing precautions Ecoexitblade Surface Mount box
Troubleshooting guide Mains terminal block
Instructions on
Conversion to Surface mount Warranty information
Installation
Battery replacement
Product removal
codes, (ie: AS/NZS 3000, AS/NZS 2293). Refer to
the applicable standards for mains cabling
installation procedures and requirements.
• This product is designed for indoor
use only.
Doc no. 29-EEIS004_A
Mounting Screws