Download Print this page

RSF Woodburning Fireplaces FO-HB1 Quick Start Manual

Internal blower - insert

Download this manual

ATTENTION:

All wiring must comply with local ordinances and the National Electrical Code.

WARNING:

Moving parts may cause injury.

Risk of electric shock. Disconnect power before servicing unit.

Never unplug your blower by puling on the power cord. Always grip the plug firmly and pull straight

out from the outlet. Damage to the cord may cause a short-circuit, fire and/or electric shock.

The internal blower's role is to circulate heated air in the room where the insert is installed. Increasing air circulation

warms all air in the room and makes it more comfortable. It is not the intended purpose of this blower to propel hot

air into the room at a high velocity. Therefore, the sensation of air flowing out of the insert will be minimal during

operation. Rest assured that if the blower is operating, it is mixing the air as intended, and that the room will feel

warmer as a result.

Installation of the Internal Blower

1. Open or remove the door of the insert and remove the bottom trim. To remove the door, lift it off the hinges.

FO-HB1

Internal Blower - Insert

This blower kit includes:

•

Blower Assembly

Thermal Switch Assembly

Three wiring connections

Outlet Plug and 10' cord

Strain Relief Connector

Rubber Grommet

Ground Screw

Instructions

FO-HB1-2023-04

Need help?

Do you have a question about the FO-HB1 and is the answer not in the manual?

Page 1 FO-HB1 Internal Blower - Insert ATTENTION: All wiring must comply with local ordinances and the National Electrical Code. WARNING: Moving parts may cause injury. Risk of electric shock. Disconnect power before servicing unit. Never unplug your blower by puling on the power cord. Always grip the plug firmly and pull straight out from the outlet.
Page 2 4. Connect the wiring for all components as shown. To connect the ground, it may be necessary to separate the ground wire from the cord by gently pulling the cables. FO-HB1-2023-04...
Page 3 5. Place the blower in the bottom of the insert so that it rests within the guide provided and is sitting on the felt padding. 6. Place the thermal switch assembly in the centre of the firebox for best results. The magnets support it. Once everything is in place, tighten the strain relief connector to secure the cord. FO-HB1-2023-04...