Download Print this page

Advertisement

Quick Links

7320-GB
19/01/00 14:34

About this manual

This manual is common to several TV
models. Therefore, the model you bought
may not support some of the functions or set-
tings described hereinafter.
About the On/Off switch
The position of the ON/OFF switch
fers depending on the model. It may be loca-
ted on the front or on the right-hand side of
your set (see the drawing inside the cover
page of your manual).

For your safety

To ensure your own safety and safe opera-
tion of the equipment, observe the follo-
wing instructions thoroughly.
TV sets require sufficient ventilation to
prevent their components from overheating,
which will cause failure. Do not block the
ventilation openings at the rear. If you place
your TV set in a special piece of furniture,
make sure there is enough space for unhinde-
red air circulation. Do not place the TV set in
the close vicinity of a heater.
The TV set has been designed for use in dry
rooms. Should you use it, in exceptional
circumstances in the open air (example: on the
balcony, in the veranda or tent), you must
absolutely protect it against moisture (dew,
rain, splash water). Before switching on a cold
TV set in a warm room, you should wait until
any condensation in the screen has dried by
itself.
Maximum ambient temperature: 35°C
Maximum humidity: 85%
By the end of your TV evening or when away
from home for a longer period, we recommend
that you turn off the TV set with the
On/Off-switch.
Even when the On/Off-switch is in the
Off-position, your TV set is not fully
disconnected from the mains. To disconnect the
set completely, the mains plug must be pulled out.
The mains plug must be easily accessible.
Page 1
In the following cases, we recommend that
you pull out the mains connector:
1. During a thunderstorm. In such a case, it
is advisable that you also disconnect the TV
set from the aerial socket.
2. When odour or smoke emanates from the set.
Never attempt to open your TV set yourself.
Further information:
The TV set shielding is sufficient to prevent
X-radiation to the exterior.
Any operation performed by a non skilled
A dif-
A
person, change of high voltage or replacement
of the picture tube by a model not complying
with the manufacturer specification are likely
to cause considerable increase in X-radiation.
A TV set modified in such a way no longer
complies with the manufacturers' specification
and must not be used.
The screen is to be cleaned with liquid glass
cleaners.
• Never use abrasive products.
• Clean the cabinet with a soft cloth soaked
with neutral cleaner. Do not use solvents,
such as white spirit or alcohol-based cleaning
products since they may damage your televi-
sion.
• At regular intervals, clean the ventilation
grids at the rear of the TV set.
The terrestrial magnetic field may have an
influence on your TV set. This influence is
revealed by the coloured spots, which appear
on the screen.
Should this be the case:
• Turn the equipment off by means of the
On/Off-switch.
• Wait about one hour before switching the
set on again.
This procedure performs automatic
degaussing of the screen. Should there still be
coloured spots on the screen, repeat the
operation.
1

About cleaning

About degaussing

Advertisement

loading

Summary of Contents for THOMSON TX807

  • Page 1: About This Manual

    It may be loca- of the picture tube by a model not complying ted on the front or on the right-hand side of with the manufacturer specification are likely your set (see the drawing inside the cover to cause considerable increase in X-radiation.
  • Page 2 From now on, every time you want to use the external equipment connected, you must Note : The mains lead of the TV set is fitted with a moulded plug. Because it contains safety components select the channel number assigned to it.
  • Page 3: The Remote Control

    To key in two-digit channels (example: 10, 11, 12, etc.), hold the first digit key down to call the place- holder dash on the display (1-), then enter the second digit.
  • Page 4: Channel Search

    TV magazine to find out the actual name of correspond to the actual number of the the current programme/channel. 1. Use the key pr+ and pr- to select the chan- channels (example: Channel 4), you may nel number you wish to change.
  • Page 5 7320-GB 19/01/00 14:34 Page 5 When the line begins with VL, VH or U go to How to modify the preferences? point 5. 1. Press the menu key once. 3. When the line begins with CH or CC: 2. Adjust the picture as described above.
  • Page 6 How to switch off the set? screen page display. To switch the TV set off, press the key B on the remote control or use the On/Off switch Videotext display on the TV set.