Related Manuals for life finds LF-WDP01
Summary of Contents for life finds LF-WDP01
- Page 1 Washer/Dryer Pedestal SKU: LF-WDP01 Instruction Manual GET IN TOUCH | Monday-Friday from 7:00am-7:00pm CST help@life-finds.com 309-278-5303...
-
Page 2: Package Contents
WARNING! If you do not understand these directions, or if you have any doubts about the safety of the installation, please call a qualified technician. Check carefully to make sure there are no missing or defective parts. Improper installation may cause damage or serious injury. Do not use this product for any purpose that is not explicitly specified in this manual. -
Page 3: Assembly Steps
ASSEMBLY STEPS STEP 1 Install two Corner Legs (A) to each Base (D) piece, as shown below. Install using M5x12mm Screws (S-A), M5 Nuts (S-B), Phillips end of Allen Wrench (T-A), and Wrench (T-B). - Page 4 STEP 2 Connect both Base (D) pieces together using Connecting Leg (B), M5x12mm Screws (S-A), M5 Nuts (S-B), Phillips end of Allen Wrench (T-A), and Wrench (T-B). NOTE: Do not fully tighten M5x12mm Screws (S-A) until all Screws are in place. Secure both Base (D) pieces together using M5x12mm Screws (S-A), M5 Nuts (S-B) in the center holes.
- Page 5 STEP 3 Remove protective film from Pads (C) and apply to the corners on Base (D) pieces.
- Page 6 OPTIONAL Optional wall mounting brackets have been included to help keep the pedestal in place with continuous vibration. Attach Wall Braces (E) to Corner Legs (A) using M5x12mm Screws (S-A), M5 Nuts (S-B), Phillips end of Allen Wrench (T-A), and Wrench (T-B). Hardware to secure brackets to wall is not included and will vary depending on your mounting surface.
- Page 7 [ THIS PAGE IS INTENTIONALLY LEFT BLANK ]...
- Page 8 If any parts are received damaged or defective, please contact us. We are happy to replace parts to ensure you have a fully functioning product. help@life-finds.com 309-278-5303 FOR MORE LIFE FINDS PRODUCTS, CHECK OUT OUR WEBSITE AT: www.life-finds.com...
Need help?
Do you have a question about the LF-WDP01 and is the answer not in the manual?
Questions and answers