Related Manuals for madVR Labs NZ7 Series
Summary of Contents for madVR Labs NZ7 Series
- Page 1 Envy JVC Laser Projector Setup Guide NZ7/NZ8/NZ9 RS2100/RS3100/RS4100 www.madvrenvy.com Rev. 1.08 madVR Envy – JVC Setup Guide Copyright © madVR Labs, LLC. All rights reserved.
-
Page 2: Projector Settings
This is common in setups with larger screens, when maximum brightness is desired regardless of SDR vs HDR content. madVR Envy – JVC Setup Guide Copyright © madVR Labs, LLC. All rights reserved. - Page 3 “Natural”, Color Profile to Auto, Color Temperature to 6500K, and a Gamma to 2.4. Other settings in this Picture Mode can be set to your preference (Laser Level, Dynamic Control, Aperture, etc.), like shown below: madVR Envy – JVC Setup Guide Copyright © madVR Labs, LLC. All rights reserved.
- Page 4 (Normal) because they prefer a brighter image and the difference in gamut coverage can be indiscernible in most scenes. The Color Temp. should be set to 6500K. madVR Envy – JVC Setup Guide Copyright © madVR Labs, LLC. All rights reserved.
- Page 5 Transfer Function settings. We cover this in section 4.0.1.2. To avoid confusion later about the purpose of this Picture Mode, we recommend a custom name, assigning such as “HDR-Auto”. madVR Envy – JVC Setup Guide Copyright © madVR Labs, LLC. All rights reserved.
- Page 6 Section 2.0.2. However, there are two changes that need to be made. First, instead of setting the Content Type to SDR like described in Section 2.0.2, change the Content Type to Auto, as shown below. madVR Envy – JVC Setup Guide Copyright © madVR Labs, LLC. All rights reserved.
- Page 7 Always set the Anamorphic option to Off. If you have an anamorphic lens, this option should still be set to Off. Instead, set the Anamorphic lens option in the Envy Screen Configuration menu so it uses its AI-based anamorphic stretch instead of the JVC anamorphic stretch. madVR Envy – JVC Setup Guide Copyright © madVR Labs, LLC. All rights reserved.
- Page 8 ● If you used the Manual Picture Mode Selection covered in section 2.0.3.2, you must use a Gamma of 2.4, or whatever Gamma is selected in that Picture Mode, as in the example shown in section 2.0.3.2. madVR Envy – JVC Setup Guide Copyright © madVR Labs, LLC. All rights reserved.
- Page 9 This depends on several factors, including your display’s lumens, lens position, iris position, Laser Level, calibration settings, throw distance, and your screen size and gain. madVR Envy – JVC Setup Guide Copyright © madVR Labs, LLC. All rights reserved.
- Page 10 Screen Gain and then dividing by Pi (3.14). After determining your peak luminance, enter it in the area shown below. madVR Envy – JVC Setup Guide Copyright © madVR Labs, LLC. All rights reserved.
- Page 11 (e.g., “BT.2020” or “BT.709”), and check the JVC Picture Mode menu to confirm the projector is using the corresponding correct color space (revisit steps 2 and 3 in the Projector Settings section). madVR Envy – JVC Setup Guide Copyright © madVR Labs, LLC. All rights reserved.
Need help?
Do you have a question about the NZ7 Series and is the answer not in the manual?
Questions and answers