4
" STEREO SYSTEM RACK
ASSEMBLY INSTRUCTIONS
KENWOOD
KENWOOD
CORPORATION
(© PRINTED IN U.S.A. B61-0579-00(TOCABI)
(M)
R0354
IMPORTANT:
-
———
—
-
`
= Notes on Assembling
* Before operating your new KENWOOD
product, read through this assem-
¢ During assembling, be sure to verify the numbers stamped on the boards.
bly manual carefully to get the most out of it.
e Mount the rear panel after assembling the side panel оп the bottom shelf
• Save this assembly instructions.
|
|
a
at a right angle.
5
Before Assembling
for adhesive.
Be sure to remove
any excess glue before it dries.
* Be sure to check that all parts are accounted for before disposing of the
Handling
Precautions
packing case.
e A Phillips screwdriver and a mallet are required for assembling.
* Tempered glass is used for the glass doors for providing sufficient strength.
* Be carefull not to damage the floor and rack.
However,
pay attention not to apply excessive
force or to scratch the
doors. Cracking or breaking of the glass may occur.
• When moving the cabinet, remove all the components from the rack be-
fore carrying the cabinet. Also do not grasp the top shelf when carrying.
* To allow head radiation from the components, leave a space of 4 inches
between the cabinet and wall.
* Do not place the cabinet in a location subject to direct sunlight or near
a heater, an air-conditioner, or a place with high humidity.
IMPORTANT SAFEGUARDS
A Cal
n : Read this page carefully to keep your safety.
A \
|
)
ы"
ы
›
Please read all of the safety and operating instructions before operating this unit.
4.
Impact — Avoid placing the unit on an unstable surface. Install itton a horizontal
For к
"Нв, follow all warnings placed on the unit and adhere to the operating; TY
surface not subject to excessive dirt or vibrations.
апа use Å . uctions. These safety and operating instructions should be retained for- pe
ә
future
reference.
1. Suffocation — After taking the unit out of the polyethylene bag, be sure to di-
spose of the polyethylene bag out of the reach of children. Otherwise, they may
play with
the bag, which
could
cause
hazard
of suffocation.
5. Modification — Do not attempt to open or modify the unit, for this could cause
fire hazard or malfunction.
2. Water and moisture — Do not place а liquid container, such as а vase and water
basin, on the unit. Also avoid installing the unit in a place subject to dampness.
6. Cleaning — Do not use thinner, benzine or alcohol. When cleaning the unit, wipe
with
а soft, dry cloth.
3. Heat
—
Do not install the unit near а source
of heat, such as а heater, or under
direct sunlight.
7. Abnormal smell — In the event the unit generates smoke or abnormal smell, im-
mediately switch the power OFF and unplug the power cord. After this, please
contact your dealer or nearest service station as soon as possible.
POWER OFF!
` e When mounting the top shelf and kick plate on the side panel, use glue .
il
da
Need help?
Do you have a question about the SRC-403 and is the answer not in the manual?
Questions and answers