Advertisement
Quick Links
Advertisement
Related Manuals for Kensington H3000
Summary of Contents for Kensington H3000
- Page 1 Kensington H3000 Bluetooth Over-Ear Headset. Register your headset at kensington.com/register...
- Page 2 1. The headset, USB-C charging cable, and USB-A adapter are stored in dedicated compartments inside the travel case.
- Page 3 2. After removing your headset from the case, adjust the earcups so the memory foam earpads are facing each other. 3. Adjust your headset for optimal comfort and performance. Adjust the headband on both sides so the earpads rest comfortably over your ears. Adjust the rotating microphone so it is directly in front of your mouth.
- Page 4 4. The power button, Bluetooth pairing / voice assistance button, and USB-C charging port are located on the lower edge of the earcup with the earcup controls. To turn your headset on, slide the power button to the right. A blue light will illiuminate. Slide the power button to the left to turn the headset off. To enter pairing mode, press and hold the Bluetooth pairing / voice assistance button for 5 seconds.
- Page 5 5. To pair your headset with your device, slide the headset power button to the on position. Press and hold the Bluetooth pairing button for 5 seconds until the blue light flashes. Open your device's Bluetooth window and select the H3000 Headset.
- Page 6 6. Use your earcup controls to maximize your productivity. Locate the headset function buttons on the side of the earcup. Press the ">" button to go to the next track. Press the "<" to go to the previous track. Press the "+" button to increase the volume. Press the "-"...
- Page 7 7. To turn your busy lights on, press and hold the center button on your earcup for two seconds. If you would like the busy lights to flash red, press the center button twice. Press and hold the center button for 2 seconds to turn the busy lights off.
- Page 8 8. Power indicator light. The power light will turn solid blue for 3 seconds when the headset is turned on. A solid green light indicates the headset is fully charged. A slow blinking red light indicates the headset is charging. A flashing red light indicates the headset's battery is less than 10%.
- Page 10 To charge the headset, connect the USB-C charging cable to the headset's charging port. For USB-C connections, plug the USB-C end into any available USB-C port on your device. For USB-A connections, connect the USB-A adapter to the USB-C receiver, then plug the USB-A adapter into any available USB-A port. 15 minutes of charging time will provide 8 hours of headset use.
- Page 12 For support, visit kensington.com/support...
Need help?
Do you have a question about the H3000 and is the answer not in the manual?
Questions and answers