Advertisement
Quick Links
Advertisement
Subscribe to Our Youtube Channel
Related Manuals for Kensington H3000
Summary of Contents for Kensington H3000
- Page 1 Kensington H3000 Bluetooth Over-Ear Headset. Register your headset at kensington.com/register...
- Page 2 1. The headset, USB-C charging cable, USB-C receiver, and USB-A adapter are stored inside the travel case in dedicated compartments.
- Page 3 2. After removing your headset from the case, adjust the earcups so the memory foam earpads are facing each other. 3. Adjust your headset for optimal comfort and performance. Adjust the headband on both sides so the earpads rest comfortably over your ears. Adjust the rotating microphone so it is directly in front of your mouth.
- Page 4 4. The power button, Bluetooth pairing / voice assistance button, and USB-C charging port are located on the lower edge of the earcup with the earcup controls. To turn your headset on, slide the power button to the right. A blue light will illiuminate. Slide the power button to the left to turn the headset off. To pair a device, press and hold the Bluetooth pairing / voice assistance button down for 5 seconds.
- Page 5 USB-A adapter to the USB-C receiver and then plug the USB-A adapter into any available USB-A port. To connect via built-in Bluetooth, press and hold the Bluetooth pairing button for 5 seconds until the blue light illuminates, then open your device's Bluetooth window and select the H3000 Headset.
- Page 6 6. Use your earcup controls to maximize your productivity. Locate the volume buttons on the side of the earcup. Press the "+" button to increase the volume and the "-" button to decrease the volume. The center button on your earcup has many functions. Press the center button once to play or pause music. Press the center button three times to turn sidetone on or off.
- Page 7 7. Press and hold the center button for two seconds to turn the busy lights on. Press the center button twice to cause the busy lights to flash red. Press and hold the center button for 2 seconds to turn the busy lights off.
- Page 8 8. USB-C receiver indicator light. If the light on the USB-C receiver is off, the headset is not connected. A blue light on the USB-C receiver indicates the headset is connected to the device. A red light on the USB-C receiver indicates the headset is muted. 9.
- Page 11 To charge the headset, connect the USB-C charging cable to the headset's charging port. For USB-C connections, plug the USB-C end into any available USB-C port on your device. For USB-A connections, connect the USB-A adapter to the USB-C receiver, then plug the USB-A adapter into any available USB-A port. 15 minutes of charging time will provide 8 hours of headset use.
- Page 12 For support, visit kensington.com/support...
Need help?
Do you have a question about the H3000 and is the answer not in the manual?
Questions and answers