Figure 22
1. Hose clamp
2. Retainer pin
3. Pressure hose assembly
6.
Secure the supply hose to the valve using a
retainer pin.
Figure 23
1. Supply hose assembly
2. Eductor valve
g028634
4. Hose clamp
5. Retainer pin (existing)
g028635
3. Retainer pin
7
Finishing the Installation
Parts needed for this procedure:
1
Suction lance and hose (optional accessory)
Procedure
Note:
The suction lance and hose are optional
accessories. Contact your authorized Toro distributor
for more information.
Retain the suction lance and hose for later use. Read
and retain the remaining documentation on using the
Chemical Pre-Mix Kit.
12