BDA VIEWER PLUS – SCAN/ PLAY/ CAPTURE TS CHECK IF DIVERSITY MODE IS WORKING Package Contents UT-120, USB 2.0 DVB-T Demodulator x1 USB extender cable x1 CD with drivers and Windows BDA Viewer+, Configuration tool “4Band Rx Controller”...
Port B Connect TWO antennas to the A & B ports. H/W installation 1. Connect UT-120 to PC USB port with or without USB extender cable. 2. Connect the DVB-T antenna (SMA connector) to UT-120. Driver Installation on Windows 1. Click on the file \Driver_Windows\DrvInstall.exe to install the driver...
3. If necessary , you can check if the device “IT9135 BDA Device” is listed in device manager BDA Viewer Plus – Scan/ Play/ Capture TS 1. Make sure to connect UT-120 with the antenna or coaxial cable first. Copy the folder “\BdaViewer+” on the CD to your local hard disk, say C:, D:, E: or F:…...
Page 4
7. Or you can click on “Frequency Scan” to specify the frequency range to scan. Bandwidth: select the bandwidth to scan. UT-120 supports ONLY 5/6/7/8 MHz bandwidth reception. Single channel: Scan the frequency in “Start Freq.”. ...
While clicking on the “Signal Statistics” in the “Control” menu of Bdaviewer+, you may check if the diversity mode is working. If diversity mode is disabled, the two fields will be blanks as shown below. If diversity mode is enabled, the two fields will show some values as shown values. WWW.HIDES.COM.TW...
Need help?
Do you have a question about the UT-120 and is the answer not in the manual?
Questions and answers