Airthereal B50 - OZONE GENERATOR Manual

INTRODUCTION

To fully benefit from the support that Airthereal offers, register at www.airthereal.com.
READ ALL INSTRUCTIONS BEFORE USE AND KEEP THEM FOR FUTURE REFERENCE.

FEATURES

OPERATION

1. With the CONTROL KNOB in the 'Off' position, plug the unit into a wall outlet.
2. Rotate the CONTROL KNOB clockwise until it clicks into the 'On' position. This position provides the minimum output of purification. Turning the CONTROL KNOB clockwise will gradually increase the purification output of the unit.
3. Adjust the CONTROL KNOB to the desired setting. Optimum performance levels are eached when the space smells fresh and clean, with no pollution odors and no strong purification odor.
4. To turn the unit off, turn the CONTROL KNOB counter clockwise until it clicks into the 'Off' position.

CLEANING

Note: For proper operation, cleaning should be performed at least once every thirty days of use.

1. Turn the unit off and remove it from the wall outlet. Use a vacuum cleaner hose to remove debris from the air intake on the rear of the unit.
2. Using a cotton swab dipped in isopropyl alcohol, insert the cotton swab into the PURIFIER OPENING. Gently rotate the cotton swab and move the cotton swab in and out until all visible contamination is removed. Use a dry cotton swab and repeat the same motion to remove excess alcohol. Place the unit face-down on a level surface. Gently tap the rear of the unit to remove any remaining debris and excess alcohol.
   Allow the unit to fully dry before resuming operation.
   
3. Plug the unit into a wall outlet. Resume use initially using maximum purification output. Verify that the unit is properly operating. A blue glow (corona) should be visible inside of the PURIFICATION OPENING. Once proper operation is verified, adjust the CONTROL KNOB appropriately.
   

Do not operate the unit unless it is completely assembled.
NOTICE
There are no user-serviceable parts inside the unit.

SPECIFICATIONS

• Use in unoccupied space is highly recommended!
• If necessary, people should not stay in the room for more than five minutes during the treatment.
• There might be ozone smell remaining in the room after treatment.
• Open doors and windows to ventilate for at least 10 minutes after the treatment and before people return to the space.