Homewhiz Setup - Beko B5W59411AW User Manual

The , Bluetooth of your smart device should
be on and your device should be connected
to the internet during setup. Your smart
device should be close to the washing ma-
chine. After the setup, the Bluetooth can be
turned off or your smart device does not
need to be close to the washing machine.
You may use your product provided that
your smart device is connected to internet.
You can tap the "Devices" tab in the applic-
ation to view appliances paired with your
account. You may perform the user pairing
operation of these products on this page.
After the app is setup, with the HomeWhiz
Function, your washing machine can give
you instant status notifications via your
smart device.
Your washing machine will send you noti-
fications over HomeWhiz application in the
following cases:
• At the end of the programme,
• When the door of the washing machine is
opened,
• In case of water cut warning,
• In case of security warning,
To utilize the HomeWhiz feature,
ensure that the HomeWhiz app is
installed on your smart device and
that your washing machine is con-
nected to your home Wi-Fi network.
When your washing machine is not
connected to the network, it oper-
ates like a machine without Home-
Whiz function.
Your product shall run with a con-
nection to the wireless network in
your home network. The controls
made by means of the application
will be enabled through this net-
work. Therefore, the wireless signal
strength near the machine's loca-
tion must be adequate.
Operates at HomeWhiz 2.4 GHz fre-
quency band.
Please visit
to learn which Android and IOS ver-
sions are supported by HomeWhiz
application.
link
www.homewhiz.com
All safety measures described in
the "GENERAL SAFETY IN-
STRUCTIONS" titled section of the
user manual are also valid for re-
mote operation with HomeWhiz
function.

6.15.1 HomeWhiz Setup

A connection should be set between your
product and the app in order for the app to
function. Follow the steps below to estab-
lish this connection.
1. If you are adding a device for the first
time, touch "Appliances" tab on the
HomeWhiz Application. Select "ADD AP-
PLIANCE" (touch here for setting up a
new appliance) button in the upper right
corner. Perform the setup by following
both the steps below and the steps in
the HomeWhiz Application.
2. To start the setup, make sure that your
machine is turned off. Press and hold
the Temperature button and the Remote
Control Function button simultaneously
for 3 seconds to switch your machine to
HomeWhiz setup mode.
3. When in HomeWhiz setup mode, an an-
imation appears on the screen and the
Wireless Connection icon flashes until
your machine connects to the internet.
Only programme knob will be active in
this mode. Other buttons will be inact-
ive.
EN / 35